以分子模版修飾電極感測嗎啡及膽固醇

Molecularly Imprinted Polymers as Modified Electrodes for Sensing Morphine and Cholesterol

葉威明(Wei-Ming Yeh)

指導教授 ： 何國川

國立臺灣大學/工學院/化學工程學研究所/碩士(2005年)

https://doi.org/10.6342/NTU.2005.10080

摘要

本研究中主要分成三大部份， 首先我們以methacrylic acid
（MAA）為單體、trimethylolpropane trimethacrylate（TRIM）為交聯
劑，在目標分子（template）—嗎啡（morphine, MO）的存在下，利
用沈澱聚合（precipitation polymerization）的方法製作出嗎啡分子模
版（molecularly imprinted polymer, MIP），比較傳統塊狀聚合（bulk
polymerization）與沈澱聚合所製備分子模版的粒徑分布、表面形態與
表面積等特性分析，並以styrene與MAA單體掺混的方式聚合分子模
版，比較不同官能基單體掺混對嗎啡的吸附效果，分析單體官能基與
模版選擇性的影響，並在不同嗎啡濃度下測量分子模版吸附量，以
Scatchard plot估算沈澱聚合分子模版的脫附常數（KD）為0.45 mM與
吸附嗎啡的最大量（Bmax）可達186 µmole/g。

第二部分，將3,4-Ethylenedioxythiophene (EDOT)作為單體，以
電聚方式包覆沈澱聚合後之分子模版於導電玻璃ITO 上作為修飾電
極（MIP/PEDOT），以定電位方法感測嗎啡，線性感測範圍為0.1~2.0
mM，MIP/PEDOT 修飾電極的靈敏度為41.63 µA/cm2
*mM，感測下限
為0.3 mM（S/N=3），模版效率為1.11。另一方面以EDOT 做為模版
單體，分別合成嗎啡（MIP-PEDOTMO）與膽固醇（MIP-PEDOTChol）
分子模版修飾電極，以PEDOT 薄膜催化嗎啡的能力，定電位的方式
感測嗎啡，線性感測範圍為0.1~1 mM，MIP-PEDOTMO 修飾電極的靈
敏度為91.86 µA/cm2
*mM，感測下限為0.2 mM（S/N=3），模版效率為1.32。膽固醇感測方面，因為膽固醇為非電活性物質，所以無法直
接以電流的訊號判斷濃度，故於溶液中加入赤血鹽為電流指示劑，利
用MIP-PEDOTChol 修飾電極上膽固醇的特殊孔洞，對吸附膽固醇後造
成PEDOT 高分子鏈的收縮，使得指示劑分子於修飾膜中通透量增
加，間接測量指示劑電流與濃度的關係來感測溶液中的膽固醇，
MIP-PEDOTChol 修飾電極吸附膽固醇後電流變化的線性範圍為0~20
µM，靈敏度為11.768 nA/cm2
*µM，模版效率為1.81。另一方面，也
利用膽固醇容易吸附在MIP-PEDOTChol 修飾電極上的特殊孔洞，使修
飾薄膜電容發生改變，感測線性範圍為0~10 µM，MIP-PEDOTChol 修
飾電極靈敏度分別為5.92 µF/cm2
*µM，模版效率為2.21。
最後，將MIP-PEDOTMO 製備於商用IDA 上，以銀膠與FeCl3 溶
液製作成Ag/AgCl 的參考電極，電位變動在感測200 秒內不超過0.4
mV（vs. Ag/AgCl/sat’d KCl），線性感測範圍為0.01~0.10 mM，靈敏
度為0.0894 A/cm2
*mM，模版效率為4.71，感測下限可達0.02 mM
（S/N=3）。並利用微機電製程方式，自製三極式微電極感測嗎啡，線
性感測範圍為0.01~0.2 mM，MIP-PEDOTMO 修飾薄膜於自製微電極
的靈敏度為171.47 µA/cm2
*mM，模版效率為1.19，感測下限為0.2 µM
（S/N= 3）。

關鍵字

嗎啡 ； 膽固醇 ； 分子模版 ； 定電位電流感測 ； 電容感測 ； 微電極

並列摘要

In this work, molecular imprinted polymers (MIPs) of morphine
(MO) were prepared through precipitation polymerization of methacrylic
acid (MAA) and trimethylolpropane trimethacrylate (TRIM) in the
presence of MO templates. The distributions of particle size,
morphologies, and surface areas were compared with bulk polymerization.
Furthermore, the copolymers of styrene and MAA with different
functional groups were synthesized and the adsorption of MO was
measured. From the Scatchard plot, the dissociation constant and the
maximum amount of adsorption were calculated 0.45 mM and 186
µmole/g, respectively.
Poly(3,4-ethylenedioxythiophene) (PEDOT) was utilized to
immobilize the MIP particles onto the indium tin oxide (ITO) glass as a
MIP/PEDOT-modified electrode. The sensitivity of MIP/PEDOT with
amperometric detection of MO was 41.63 µA/cm2*mM, ranging from 0.1
to 2 mM. The detection limit and imprinting efficiency were 0.3 mM
(S/N=3) and 1.11, respectively. On the other hand, the PEDOT was also
used to prepare the MIP modified electrodes of MO (MIP-PEDOTMO)
and cholesterol (MIP-PEDOTChol) directly. The PEDOT film was capable
of electro-catalyze oxidize of MO and detected MO in MIP-PEDOTMO
modified electrode with the amperometric method. The sensitivity of
MIP-PEDOTMO was 91.86 µA/cm2*mM, ranging from 0.1 to 1 mM MO.
The detection limit was 0.2 mM (S/N=3) and the imprinting efficiency
was 1.32. As for the detection of cholesterol (Chol), Chol was
electro-inactive and the oxidation current of Chol can’t be obtained
directly. Therefore, K3Fe(CN)6 was served as an indicator for the current
response in the solution. As Chol was adsorbed on the MIP-PEDOTChol
IV
modified electrode, the MIP polymer chain shrank and increased the
porosity of MIP. Such an increase in porosity was expected to result in an
increase in the diffusive permeability of the MIP and an enhancement of
Faradic current of the K3Fe(CN)6. The sensitivity of MIP-PEDOT with
indirect amperometric method was 11.768 nA/cm2*µM from 0 to 20 µM.
The imprinting efficiency was 1.81. The capacitive detection of Chol has
been developed using the MIP-PEDOTChol modified electrode. A
capacitance decreased could be obtained as Chol adsorbed on the sites of
MIP film. The sensitivity of capacitance shift was 5.92 µF/cm2*µM from
0 to 10 µM and the imprinting efficiency was 2.21.
Finally, the MIP-PEDOT was prepared on the commercial
interdigital array (IDA). The Ag/AgCl reference electrode (RE) was
prepared with silver glue and FeCl3 solution. The variation of RE
potential was less than 0.4 mV (vs. Ag/AgCl’sat KCl) in 200s. The
sensitivity was 0.0894 A/cm2*mM from 0.01 to 0.10 mM and the
imprinting efficiency was 4.71. The detection limit was 0.02 mM (S/N=3).
With micro-fabrication process, we were able to fabricate the
MIP-PEDOT electrode in a three-electrode system for sensing MO. The
sensitivity on the microelectrode was 171.47 µA/cm2*mM from 0.01 to
0.2 mM MO. The imprinting efficiency and detection limit were 1.19 and
0.2 µM (S/N=3), respectively.

並列關鍵字

Morphine ； cholesterol ； molecular imprinted polymer (MIP) ； amperometric detection ； capacitive detection ； micro- electrode

參考文獻

[37] 陳宏杰，自組裝薄膜分離與電流式分子感測之研究，國立台灣大學, 台北 (2004).

[100] 董才士，以PEDOT導電高分子及其衍生物與普魯士藍搭配之電致色變元件性質最適化與長期穩定性研究，國立台灣大學化學工程研究所碩士論文，台北，台灣 (2004).

[1] K. Yano, I. Karube, “Molecularly Imprinted Polymers for Biosensor applications,” Trends Anal. Chem., 18, 3 (1999).

[2] G. Winter, A. D. Griffiths, R. E. Hawkins, H. R. Hoogenboom, “Making Antibodies by Phage Display Technology”, Annu. Rev. Immunol., 12, 433 (1994).

[3] P. J. Hudson, “Recombinant antibody fragments,“ Curr. Opin. Biotechnol., 9, 395 (1998).