使用兩種填料真空硬銲Incoloy 800之研究

The Study of Vacuum Brazing Incoloy 800 Using Two Fillers

王正彥(Cheng-Yen Wang)

指導教授 ： 薛人愷

國立臺灣大學/工學院/材料科學與工程學研究所/碩士(2014年)

https://doi.org/10.6342/NTU.2014.10245

摘要

無資料

關鍵字

鎳基填料 ； 銅填料 ； 鎳基合金 ； 顯微結構組織 ； 剪力強度

並列摘要

In this research, both copper foil and Ni-based V2177 foil are applied in brazing IN-800 substrate. Analyses of the microstructural evolution of the joint by controlling brazing temperature, time and the thickness of foil were performed. Selected specimens were applied in shear test in order to evaluate the effect of microstructure on the brazed joint. First, IN-800/Cu/IN-800 brazed joints show no precipitate, and their shear strengths do not change with the brazing temperature and thickness of the filler foil. The crack is originated from Cu-rich matrix based on SEM microstructure analysis of the fractured surface. IN-800/VZ2177/IN-800 brazed joints include two types of precipitates, B2Cr5P and Cr4Ni3P4, in the Ni-based matrix, and both are coarsened with increasing brazing temperature and/or time. However, B2Cr5P phase is coarsened more prominent than Cr4Ni3P4 at higher temperature due to enhanced diffusion rate of boron at higher temperature. Coarsening of B2Cr5P phase is also enhanced by increasing the thickness of filler foil. Based on the result of SEM microstructural examination and XRD analyses of the fractured surfaces, the crack are originated from B2Cr5P phases, and the shear strength is decreased with the coarsened B2Cr5P phase. Optimized conditions are brazed between 1050℃ and 1080℃ for 10 ~ 20 min and using the foil with 40 μm in thickness.

並列關鍵字

Ni-based filler ； Copper filler ； Ni-based alloy ； Microstructure ； Shear strength

參考文獻

2. W.F. Smith, Structure and Properties of Engineering Alloys 1993: McGraw-Hill Science/Engineering/Math.

3. C.H Hsu, H.W. Hsu, T.Y. Yeh, R. K. Shiue, Developing Corrosion-resistant Joints Applied in the Plate Heat Exchanger, Advantace Material Resarch, Vol. 410, 2012, pp. 191-195.

8. X. Yuan, C. Yun Kang, and M.B. Kim, Microstructure and XRD analysis of brazing joint for duplex stainless steel using a Ni–Si–B filler metal. Materials Characterization, 2009. 60(9): p. 923-931.

9. F. Jalilian, M. Jahazi, and R.A.L. Drew, Microstructural evolution during transient liquid phase bonding of Inconel 617 using Ni–Si–B filler metal. Materials Science and Engineering: A, 2006. 423(1–2): p. 269-281.

11. T. Wang, et al., Electron beam welding of Ti-15-3 titanium alloy to 304 stainless steel with copper interlayer sheet. Transactions of Nonferrous Metals Society of China, 2010. 20(10): p. 1829-1834.