並列摘要
The increasingly demanding performance required of today’s antennas necessitates higher-accuracy measurement techniques. Much attention has been given to antenna measurements in the frequency. The accuracy of conventional measurement of antenna radiation pattern in chamber using frequency-domain technique is dependent on the dimensions of chamber and the quality of its absorbing materials. One of the main contributory causes of error in chamber is the reflection of waves from the surfaces of the chamber. Time-domain techniques make it possible to separate the direct signal from a multitude of waves reflected from the chamber walls. This thesis describes the antenna time-domain measurement technique, time-domain gating, the error sources, and the results of some experimental studies.
參考文獻
[1] IEEE standard test procedures for antennas, ANSI/IEEE Std 149-1979, published by IEEE, Inc., 1979, distributed by Wiley-Interscience.
[4] de Jongh, R.V.; Hajian, M.; Ligthart, L.P., “Time Domain Antenna Measurements: Implementation And Verification Of A Novel Technique,” Microwave Conference and Exhibition, 27th European ,Page(s): 470 —475 .
[5] 王聲珵; 田振揚; 丁原梓; “使用頻域/時域交互轉換方法校正天線因數,” 中山科學研究院第三研究所, Page(s):54-57.
[8] Maricevic, Z.A.; Sarkar, T.K.; Hua, Y.; Djordjevic, A.R., “Time-domain measurements with the Hewlett-Packard network analyzer HP 8510 using the matrix pencil method,” Microwave Theory and Techniques, IEEE Transactions on , Volume: 39 Issue: 3 , March 1991, Page(s): 538 —547.
[2] Constantine A. Balanis, Antenna Theory, published by John Wiley & Sons, Inc., 1997, New York, ch16, pp. 839-883.