- 學位論文
7075鋁合金經微弧氧化處理後之耐磨耗特性
Wear resistance of 7075 aluminum alloy by micro-arc oxidation
若您是本文的作者，可授權文章由華藝線上圖書館中協助推廣。
摘要
微弧氧化處理為現今表面改質新興技術之一，其技術特點為在試件表面長出一氧化膜，進而提升本身硬度及改變基材之材料特性。有許多複雜的因素會影響微弧氧化處理後的氧化膜特性。本論文將討論，微弧氧化處理應用在鋁合金7075之上，主要供應電源形式為雙極脈衝方式，控制雙極電流密度進一步探討膜層特性與耐磨耗特性之間的關係。利用掃描式電子顯微鏡觀察不同的雙極電流密度，對於其顯微結構之影響。實驗結果顯示，當雙極電流密度愈趨增加時，其表面之多孔層孔洞直徑大小也隨之增大。以PLINT磨耗試驗機進行block-on-roller式磨耗測試，於電流密度1412及1414時，其膜層硬度值為853HV及794HV，遠大於鋁合金之硬度，於耐磨耗之特性也有所增強。
並列摘要
The aluminum ceramic coatings were prepared on 7075 Al alloy by Micro-arc Oxidation (MAO) technique. Parameters of the MAO coating process is multiplex. In this paper, the major coating parameters was the bipolar pulsed current. After the coating, we observe the surface morphology in SEM (Scanning Electron Microscopy) and discuss the mechanical property for coating Al alloy. The results show the surface morphology porosity will increase accompanied by the bipolar current density increase. The wear properties were tested by PLINT block-on-roller. when the current density condition is 1412 and 1414 , the micro-hardness of the polished MAO process coating was 853 HV and 794 HV , and the wear resistance increased obviously.
參考文獻
3. Hong fang ,M. Zhi bao,L. and IN Feng ling,Y. “Electroplating of aluminum alloys”, Corrosion & Protection, 24, pp. 126-163,(2003).
4. Tsangaraki-Kaplanoglou, et al., “Effect of alloy types on the anodizing process of aluminum”, Surface and Coatings Technology, 200, pp. 2634-2641,(2005).
5. Soon-Moon Jeong, et al. “Stability improvement of organic light-emitting diode with aluminum cathode deposited by ion beam assisted deposition method”, Thin Solid Films, 475, pp. 227- 230,(2005).
13. J.A. Curran,T.W. Clyne, “Porosity in plasma electrolytic oxide coatings”,Acta Materialia 54, pp. 1985-1993,(2006).
15. A.L. Yerokhin, A. Shatrov, V. Samsonov, P. Shashkov, A. Pilkington,A. Leyland, A. Matthews, Surface and Coatings Technology,199,pp. 150-157,(2005).