應用於氣隙型加熱之高頻感應加熱電路設計

The Design of a High Frequency Induction Heating Circuit for Heating in Air Gap Type

李政潔(Cheng-Chieh Li)

指導教授 ： 何金滿

中原大學/工學院/電機工程研究所/碩士(2008年)

https://doi.org/10.6840/cycu200800367

摘要

應用於感應加熱之技術已可達到系統上的高效率、高品質與低污染之特性，尤其於金屬表面快速加熱部份，加熱處理技術已在相關領域中佔有一席重要之地位。

本篇論文針對具導電性之物件設計加熱器電路，實驗架構為電壓饋入式全橋型電源轉換裝置，應用於負載串聯共振式感應加熱系統之上，功率開關具備零電壓切換的性能，具降低功率開關切換應力、切換損失及改善電磁干擾現象等特點，並以電路中具氣隙之諧振電感對加熱物件進行加熱，成功達到提高電路系統之效率與加熱速度之目的。

最後，本研究將對感應加熱系統其操作特性與整體效率進行量測與說明，同時對於不同實驗條件下之加熱效果進行探討。

關鍵字

全橋 ； 反流器 ； 感應加熱 ； 氣隙

並列摘要

The induction heating process could reach high efficiency, high quality, and low pollution . The heating technique is important in related fields, especially in the rapid heating on the surface of metal.

In this thesis, a high frequency induction heater for heating of conducting working piece has been designed. A load series resonant induction heating system with voltage source full bridge inverter has been constructed and tested . The system can reach low switching losses, low component stresses, and low electromagnetic interferences of power semiconductor devices.

Finally, the control characteristics, efficiency, and experiment results with different parameters were measured and analyzed.

並列關鍵字

Air Gap ； Inverter ； Full Bridge ； Induction Heating

參考文獻

[4] I. Khan, J. Tapson and I. de Vries, “An induction furnace employing a 100 kHz MOSFET full-bridge current-source lord-resonant inverter” ,Industrial Electronics, Proceedings. ISIE 98. IEEE International Symposium on,pp.530-534, 1989

[5] E. J. Davies and P. G. Simpson, Induction Heating Handbook,

[7] Mu-Ping Chen, Jan-Ku Chen, K. Murata, M. Nakahara and K. Harada, “Surge analysis of induction heating power supply with PLL,” IEEE Trans. on Power Electronics, Vol. 16, No. 5, pp. 702-709, Feb. 2001.

[8] J. Shao, R.L. Lin, F.C. Lee and D.Y. Chen, “Characterization of EMI performance for hard and soft-switched inverters,” in IEEE APEC, Vol. 2, pp. 1009-1014, Feb. 2000.

[9] J. Acero, J. M. Burdio, L.A. Barragan, D. Navarro and S. Llorente, “EMI improvements using the switching frequency modulation in a resonant inverter for domestic induction heating appliances,” in IEEE PESC, Vol. 4, pp. 3108-3112, 2004.