修正式拋物面車燈設計

Design of Modified Parabolic Vehical Headlight

李仰皓(Yang-hao Li)

指導教授 ： 張榮森

國立中央大學/理學院/光電科學與工程學系/碩士(2014年)

摘要

本論文主要目的是選用拋物面作為車燈反射罩的設計，使用蒙地卡羅光線追跡法設計出符合車燈法規標準的近光燈與遠光燈，使用拋物面反射罩，將LED發光面朝上進行反射罩配置，降低由車燈產生多餘雜散光，達到減少車燈對來車駕駛造成眩光之目的。設計出一種高光源利用率77%、低功耗的車燈照明系統設計，使用上半拋物反射罩，車燈體積更有利於汽車本身流線車形設計。

關鍵字

蒙地卡羅 ； 車燈 ； 拋物面

並列摘要

The present study mainly selects the paraboloid to be a new of design the headlight reflector. Using Monte-Carlo method to design a low beam headlight and high beam headlight which consistent to the ECE regulations.Using the characteristics of paraboloidal reflector, I put the luminous surface right side up to. Reduce the unwanted stray light of the headlight, and moreover , to reduce the influence of glare for a coming driver causing by the headlight. Also, What we design is a kind of high photosource utilization (almost as high as 77%), the low-power consumption headlight lighting system ,and since just using the top half of the parabolic reflector, the volume of the car is more conducive to the car itself and the streamline car-shaped design.

並列關鍵字

Monte-Carlo ； headlight ； paraboloid

參考文獻

[5] 蔡漢文，“車輛頭燈照明設計之發展與研究”，光學工程季刊第60期，頁35~44，1997。

[4] Gerhard Lindae, “Improvement of Low-Beam Pattern by use of Polyellipsoid Headlamps ( PES )”, SAE850228, p2.216~2.227.

[9] A. Zauskas, F. Ivanauskas, R. Vaicekauskas, M. S. Shur, and R. Gaska, “ Optimization of mulitichip white solid state lighting source with four or more LEDs,” Proc. SPIE 4445, p148~ p155 (2001).

[10] S. Nakamura, T. Mukai, and M. Senoh, “Candela-class high-brightness InGaN/AlGaN double-heterostructure blue-light-emitting diodes,” Appl. Phys. Lett. 64, p1687~p1689 (1994).

[11] C. C. Yang, C. M. Lin, Y. Chen, Y. T. Wu, S. R. Chuang, S. F. Huand, and R. S. Liua, “Highly stable three-band white light from an InGaN-based blue lightemitting diode chip precoated with (oxy)nitride green/red phosphors,” Appl. Phys. Lett. 90, p123503~p12505 (2007).