具高深寬比深微孔同軸微型零件之擠壓研究

Study of Extrusion for Manufacturing Co-Axial Microparts with High Aspect Ratio Hole

許源泉(Yuan-Chuan Hsu) ； 林萬益(Wann-Yih Lin) ； 楊東昇(Tung-Sheng Yang) ； 李俊賢(Chun-Hsien Lee)

《技術學刊》 21卷3期 (2006/09) Pp. 237-242

https://doi.org/10.29507/JT.200609.0004

摘要

本研究乃是利用具有盲孔的小胚料進行前向擠壓，以獲得具高深寬比深微孔之微型零件，其中先進行精微擠壓之有限元素模擬分析，以瞭解其變形趨勢發展，再利用自行設計建構的精微擠壓成形機具進行前向擠壓實驗，並將相關製程參數及微型擠壓件量測結果做一分析比較，以探討不同擠壓比、填充料直徑和填充料種類對微型擠壓件之影響。

關鍵字

擠壓 ； 有限元素分析 ； 深微孔

並列摘要

To obtain micro-parts with high aspect ratio holes, forward extrusion is used to process smaller billets with blind holes. First, the finite element simulation analysis of micro-extrusion should be done to find the tendency and development of billet deformation. Then, micro forward extrusion experiments should be done using the micro-extrusion facilities designed and constructed by the author. Finally, the related process parameters gained from simulation and experiments and the measured results of micro-extruded parts will be employed for analysis and comparison. Thus the influences of different extrusion ratios, filler diameters, and filler materials on micro extruded parts have been explored.

並列關鍵字

extrusion ； finite element method ； micro-deeper hole