- 期刊
- OpenAccess
Calculation of Contact Stress And Flexural Stress Calculation For The New Type Composite Modified Gear
並列摘要
This paper introduces the method for calculating the contact stress in a meshing cycle and flexural stress of the new type composite modified gear. At the same time, examples of different tangential and radial modified gears are presented. It provides the necessary foundation for the study of new type of variable tooth thickness gear based on composite modification. In addition, ANSYS finite element method simulation was applied for contact stress and bending stress analysis to verify the correctness of the theoretical calculation.
被引用紀錄
Huang, P. Y. (2009). 奈微通道電鍍填充行為研究 [master's thesis, Tatung University]. Airiti Library. https://www.airitilibrary.com/Article/Detail?DocID=U0081-3001201315104518
延伸閱讀
- 黃麒（2008）。A study on analytical calculation model for root stresses of straight-toothed conical gears〔碩士論文，國立中央大學〕。華藝線上圖書館。https://www.airitilibrary.com/Article/Detail?DocID=U0031-0207200917355093
- 林旻鴻（2014）。Flank Modified Conical Gear Drives with Small Gear Ratio: Design, Analysis and Fatigue Test〔碩士論文，國立中央大學〕。華藝線上圖書館。https://www.airitilibrary.com/Article/Detail?DocID=U0031-0412201512042031
- Santander, J. L. G., Porras, P. C., Ratis, Y. L., Isidro, J. M., & Córdoba, P. F. D. (2010). Calculation of Some Integrals Arising in Heat Transfer in Grinding. Mathematical Problems in Engineering, 2010(), 391-404-125. https://doi.org/10.1155/2010/535801
- 駱建成（2012）。Characterization of the Modified Curvilinear Gear Set on Tooth Contact Stress and Loaded Transmission Errors〔碩士論文，國立中央大學〕。華藝線上圖書館。https://www.airitilibrary.com/Article/Detail?DocID=U0031-1903201314455156
- Liu, J. Y., Yu, X. G., & Han, Q. K. (2019). Research on Fault Diagnosis of Aeronautic Gear Based on Permutation Entropy and SVM Method. 中國機械工程學刊, 40(4), 413-422. https://www.airitilibrary.com/Article/Detail?DocID=02579731-201908-201909110008-201909110008-413-422