- 期刊
Numerical Simulation of Solidification Process of Small Die Steel Ingot
摘要
The three‐dimensional modeling software Pro.E was used to complete the modeling of small P20 ingot, and then the filling and solidification process of the small die steel ingot was simulated in the ProCAST software. The temperature field results of the small die steel ingot were analyzed, and it was predicted that the loose defect would occur right below the primary shrinkage hole at the ingot rise.
參考文獻
A. Abdullin, A. Ershov: End-to-End Simulation of Casting and Metal-Forming Operations with ProCAST and Qform Software, Metallurgist, vol. 58(2022)No.5, p. 339–345.
Z.S. Zhang, X.L. ZHU, M.G. Shen, G.W. Ao: Simulation Study on Effect of Chassis Water Cooling on Solidification of Eleven Tons Flat Steel Ingot, Metalurgija, vol. 59(2022)No.4, p. 467–469.
J.P. Xie: Current situation and trend of cast steel technology development, Foundry, Vol. 71(2022)No.4, p. 395-402.
延伸閱讀
- 黃耀弘（2012）。Numerical Simulation of Melt Spinning Process of Profile-Conjugated Fibers〔碩士論文，國立臺北科技大學〕。華藝線上圖書館。https://doi.org/10.6841/NTUT.2012.00293
- Zhang, Q. Q., Han, Z. N., Ning, S. H., Liu, Q. Z., & Guo, R. W. (2015). Numerical Simulation of Rock Cutting in Different Cutting Mode Using the Discrete Element Method. Journal of GeoEngineering, 10(2), 35-43. https://doi.org/10.6310/jog.2015.10(2).1
- 李榮顯、陳怡安、周金龍（2001）。Application of Numerical Simulation for Wear Analysis of Warm Forging Die。鍛造，10(4)，1-6。https://doi.org/10.29791/Forging.200112.0001
- Chiang, C. C., Yuan, Y. J., Huang, S. H., Chang, C. H., Hsieh, H. S., & Chang, M. (2013). Effects of Drilled-Shaft Tip Grouting in Numerical Simulations. 淡江理工學刊, 16(1), 41-44. https://doi.org/10.6180/jase.2013.16.1.06
- 陳宇宏、許富淵（2019）。The Validation of solidification shrinkage models for Ductile Iron Casting。鑄造工程學刊，45(3)，25-38。https://www.airitilibrary.com/Article/Detail?DocID=10116761-201909-201910020024-201910020024-25-38