直接水熱法製備含鈦中孔洞分子篩SBA-15及其特性鑑定與光催化性質

Characterization and Photocatalytic Properties：Ti-containing SBA-15 Prepared by Modified Direct Hydrothermal Method

張仁偉(Ren-Wei Chang)

指導教授 ： 簡淑華

國立臺灣大學/理學院/化學研究所/碩士(2006年)

https://doi.org/10.6342/NTU.2006.02241

摘要

無資料

關鍵字

含鈦SBA-15 ； 一氧化氮光分解 ； 柳酸光分解

並列摘要

Titanium-containing SBA-15 (Ti-SBA-15) was synthesized via a modified hydrothermal method, prepared as following: an amount of triblock copolymer P123 (EO20PO70EO20) was dissolved in 1 M HCl solution, followed by the dropwise addition of a mixture of tetraethylorthosilicate (silicon source, TEOS) and tetraethylorthotitanate (titanium source, TBOT) with the desired ratio of Ti and Si (in mole). After stirring 24 h, adding some amount of 2 M NaOH solution to adjust the desired pH of the synthesis system, and then hydrothermal treatment at 80 ℃ for 24 h. The final solid was collected by filtration, washed with water, and dried at room temperature, and then calcinated at 550 ℃ for 6 h. The structure characterization of Ti-SBA-15 and its photocatalytic properties was investigated.
The element analysis results indicated that the amounts of titanium in pH-adjusted Ti-SBA-15 are higher than that of Ti-SBA-15 as much as one order of magnitude. HRTEM images of all Ti-SBA-15 show well-ordered hexagonal arrays of mesopore with one-dimensional channels, and TiO2 aggregated layer at outside surface of pH-adjusted Ti-SBA-15 was observed. With increasing the pH value of the synthesis system, some TiO2 aggregated seriously to form nanoparticles anchored on the surface of Ti-SBA-15. N2 adsorption isotherm (77 K) shows the adsorption type of all Ti-SBA-15 are type Ⅳ with H1 hysteresis loop, which is typical for mesoporous materials with 2-D-hexagonal structure. From UV-Visible spectrum, Ti/Si = 0.05 shows the absorption band at 200-250 nm, indicated that titanium at framework site. When Ti/Si ratio increased, another adsorption band at about 300 nm emerges, indicated titanium distributed at extraframework site. X-ray adsorption spectrum evidenced that titanium at four coordination state in Ti-SBA-15, and titanium mainly at six coordination state in pH-adjusted Ti-SBA-15. From pyridine adsorption IR spectrum, all Ti-SBA-15 show Lewis acid properties.
Nitric oxide photocatalytic analysized by in-situ Electron Paramagnetic Resonance (in-situ EPR) indicated that Ti-SBA-15 adjusted pH=1 has the best photocatalysis for NO degradation with high nitrogen selectivity in products. Simultaneously, the photodegradation test of salicylic acid also shows that Ti-SBA-15 adjusted pH=1 exhibited the best performance. The high photocatalytic activity of Ti-SBA-15 adjusted pH=1 is contributed to TiO2 layer distributed uniformly at the outside surface of molecular sieves.

並列關鍵字

Titanium-containing SBA-15 ； NO photodecomposition ； photodegradation of salicylic acid

參考文獻

J.B. Higgins, J.L. Schlenkert, J. Am. Chem. Soc. 1992, 114, 10834.

[3] J.Y. Ying, C.P. Mehnert, M.S. Wong, Angew. Chem. Int. Ed. 1999, 38, 56.

Curr. Opin. Colloid In. 2003, 8, 109.

[11] A. Fujishima, T.N. Rao, D.A. Tryk, J.Photochem.Photobiol C 2000, 1, 1.

[22] L. Kevan, Z.H. Luan, E.M. Maes, P.A.W. van der Heide, D.Y. Zhao,