鋼筋混凝土剪力牆連接梁之剪力強度預測行為研究

Analytical Study of Shear Strength Behavior of Reinforced Concrete Coupling Beams

林宜靜(Yi-Ching Lin)

指導教授 ： 黃世建

國立臺灣大學/工學院/土木工程學研究所/碩士(2012年)

https://doi.org/10.6342/NTU.2012.03137

摘要

台灣位處於環太平洋地震帶上，鋼筋混凝土建築物耐震能力為不可缺少之考量，其中又以剪力牆系統被廣泛使用於耐震設計中。由於建築使用需求，常對剪力牆開孔，而造成剪力牆抵抗側力之能力下降，但若於剪力牆系統中配置鋼筋混凝土剪力連接梁便能補足整體剪力牆系統之韌性行為。然而，現今並未能完全了解剪力連接梁之行為及其鋼筋配置細節原理。因此本研究旨在探討剪力連接梁之剪力強度及其變形之關係。
本研究先蒐集國內外鋼筋混凝土剪力連接梁試體之測試數據，採用ACI 318-11規範及壓拉桿模型之剪力預測強度與試體之撓曲預測強度，並將剪力衰減列入考量，而利用剪力強度衰減模型預測破壞模式、剪力強度與試體位移等諸多參數。

關鍵字

鋼筋混凝土剪力連接梁 ； 破壞模式 ； 剪力強度 ； 位移 ； 壓拉桿模型

並列摘要

Reinforced concrete buildings in seismic zones have been limited to low-rise or medium-rise buildings worldwide because of a lack of structural safety against earthquake. A high-rise reinforced concrete building can be built with the aids of the structural walls which provide lateral resistance efficiently. Architectural considerations usually result in window and door openings in structural walls, which divided a single wall into more slender walls connected by short beams, referred to as coupling beams. However, the behavior of coupling beams is still uncertain. Therefor the research focuses on the relationship between shear strength and deformation of coupling beams.
This research collected available test data first and used the ACI 318-11 code and the Strut-and-Tie model to predict shear strength. Shear degradation was also taken into consideration. The failure model、shear strength and deformation capacity of coupling beams can be predicted using proposed shear degradation model.

並列關鍵字

reinforced concrete coupling beams ； failure mode ； shear strength ； deformation capacity ； strut and tie model

參考文獻

[3] 王亭惟，「鋼筋混凝土剪力連接梁耐震鋼筋配置之探討」，碩士論文，國立台灣大學土木工程系，台北，民國100年。

[21] 鄭志宏，「鋼筋混凝土剪力連接梁反覆載重測試之研究」，碩士論文，國立台灣大學土木工程系，台北，民國99年。

[1] Tassios, T. P. Moretti, M., and Bezas, A., “On the Behavior and Ductility of Reinforced Concrete Coupling Beams of Shear Walls,” ACI Structural Journal, Vol. 93, No. 6, Nov.-Dec. 1996, pp. 711-720.

[2] Galano, L., and Vignoli, A., “Seismic Behavior of Short Coupling Beams with Different Reinforcement Layouts,” ACI Structural Journal, Vol. 97, No. 6, Nov.-Dec. 2000, pp. 876-885.

[4] ACI Committee 318, “Building Code Requirements for Structural Concrete (ACI 318-11) and Commentary (ACI 318R-11), ” American Concrete Institute, Farmington Hills, 2011.