應用於感應加熱的負載串聯共振電壓型反流器設計與研製

Design and Implementation of Voltage-Fed Load Series Resonant Inverter for Induction Heating System

許國展(Kuo-Chan Hsu)

指導教授 ： 何金滿

中原大學/工學院/電機工程研究所/碩士(2002年)

https://doi.org/10.6840/cycu200200066

摘要

感應加熱技術是二十世紀初才開始應用於工業界，由於它具有加熱速度快、安全性高、產品質量好、幾乎無環境污染等許多優點，而得到迅速的發展。另一方面，隨著半導體元件製作技術的進步，反流器上的功率開關能夠操作在更高頻率的範圍，使得高頻感應加熱裝置具備了輕、薄、短、小、效率高的特色。
本論文的主要目標在建立一個以單晶片TMS320C240微處理器為基礎的數位化高頻感應加熱器。此數位化高頻感應加熱器已將切換頻率提高至70kHz，減短加熱過程所需的時間，並使用零電壓切換相移式脈波寬度調變技術，降低功率開關元件之切換損失、切換應力及電磁干擾。有鑑於加工物件在加熱過程中，其本身的電氣特性會隨之而改變，致使共振頻率亦隨著加熱時溫度之變化而變動。所以利用變頻控制技術來使驅動頻率追隨共振頻率，促使系統在運轉時的效率隨時保持於最佳狀態。同時，為了能夠調整輸出功率，乃藉由相移脈波寬度調變控制技術來改變輸出電壓的工作週期，來達成此一目標。
最後，將對加熱時產生的負載參數變化現象以及在負載變動下反流器的運轉性能等進行實際的量測及探討，並驗證此零電壓切換技術的確提高了系統的整體效率。

關鍵字

加工物件 ； 微處理器 ； 數位化高頻感應加熱器 ； 零電壓切換相移式脈波寬度調變技術 ； 電磁干擾

並列摘要

Since the early twentieth century, induction heating have been widely used and rapidly developed in the industrial applications because of their distinctive advantages such as high-speed heating, safety, high products quality, cleanliness, and etc.. In addition to this, with tremendous advance in the latest power semiconductor devices permiting switches of inverters to operate under high frequencies, the induction heating systems have become lighter, compacter, and more efficience.
The main purpose of this study is to investigate the application of a single chip, TMS320C240, microprocessor to a fully digital high frequency induction heating system. By using the phase-shifted full-bridge zero-voltage-switched PWM technique, this system can reduce switching loss, component stress, and electromagnetic interference of power semiconductor devices. In induction heating applications, because the electrical characteristics of the workpieces will change in the processing, the circuit resonant frequency must be changed in accordance. Hence, the variable frequency control technique is used for tracking the resonant frequency to keep the system operating at the optimal condition. The phase-shift Pulse-Width-Modulated (PWM) is used for regulating the duty-cycle to control the output power.
Finally, the efficiency of this heater are measured and analyzed under load variations. Experimental results show that the ZVS PWM technique can improve the efficiency of this system.

並列關鍵字

fully digital high frequency induction heating s ； microprocessor ； workpieces ； electromagnetic interferences ； phase-shifted full-bridge zero-voltage-switched

參考文獻

[17]鄭一鋒， “相移式零電壓切換高頻感應加熱器之設計與研製” ，私立中原大學電機工程學系研究所碩士論文，民國九十年。

[4]I. Khan, J. Tapson, I. de Vries, “ An induction furnace employing a 100 kHz MOSFET full-bridge current-source load-resonant inverter” , Industrial Electronics, 1998. Proceedings. ISIE '98. IEEE International Symposium on, 1998,pp. 530 -534 vol.2

[6]H. W. E. Keertzen, J. A. Ferreira, J. D. Van Wyk, “A Comparative Study of Single Switch Induction Heating Converters Using Novel Comparative Effectivity Concept” ,IEEE APEC Records,1992,pp. 298-305.

[8]E. J. Dede, J. Jordan, V. Esteve, J. M. Espi, S. Casan, “Series and parallel resonant inverters for induction heating under short-circuit conditions considering parasitic components ”Power Electronics and Drive Systems, 1999. PEDS '99. Proceedings of the IEEE 1999 International Conference , 1999, pp.659 -662 vol.2

[9]L. R. Egan, E. P. Furlani, “A Computer Simulation of an Induction Heating System” ,IEEE Trans. on Magnetics;Vol.27,No.5,Sept l991,pp. 4343-4354.