雜訊相依模型與模組設計最佳化運用在離散時間積分三角類比數位轉換器

Noise Correlation Model and Model-based Design Optimization for Discrete-Time Sigma-Delta Modulators

盛子恩

指導教授 ： 陳福川

國立交通大學/電機學院/電機與控制工程系所/碩士(2010年)

https://doi.org/10.6842/NCTU.2010.01051

摘要

傳統高階積分三角調變器的設計上，主要是依賴行為模擬的方法。然而此方法相當耗時。本論文是第一個提出使用模組化設計的方法去設計積分三角調變器。在速度上，使用模組化設計的方法將會比使用行為模擬的方法快上萬倍。由於先前非理想雜訊以及失真模型的不完備，模組化設計的方法一直無法真正的去實現。如今，由於積分器充放電雜訊模型以及放大器非線性直流增益諧波失真模型的推出，使得模組化設計方法得以實現。然而，使用模組化設計方法將會遭遇到雜訊相依的問題；本論文將會提出雜訊相依模型以便解決這個問題。除此之外，本論文也同時提出了積分三角調變器最佳化設計流程。對照於一篇積分三角調變器設計實例，模組化積分三角調變器最佳化設計將可以使用更短的時間去達到更高的訊號對雜訊以及失真比，同時降低積分三角調變器的功率消耗。

關鍵字

積分三角轉換器

並列摘要

The conventional high-level SDM synthesis is mainly based on behavior simulation which is very time-consuming. This thesis is the first one in the literature to propose model-based SDM synthesis. Model-based method can be at the order of ten thousand times faster than simulation-based method, but it is never realized before due to the incompleteness of non-ideality models. The recent establishment of settling noise model [18] and OTA distortion model [17] facilitates model-based SDM designs. Nonetheless, new problem associated with model-based method arises, notably correlation between noises. Noise correlation models here are derived. In addition, a SDM design optimization scheme is proposed, which incorporates a comprehensive power consumption model. This model-based optimization is tested against a published SDM design, achieving higher SNDR and lower power results in a much shorter design time.

並列關鍵字

Sigma-Delta Modulator

參考文獻

[1] B. E. Boser and B. A. Wooley, “The Design of Sigma-Delta Modulation Analog-to-Digital Converters,” IEEE J. Solid-State Circuits, vol. 23, pp. 1298-1308, Dec. 1988.

[2] S. R. Norsworthy, I. G. Post and H. S. Fetterman, “A 14-bit 80-kHz Sigma-Delta A/D Converter: Modeling, Design, and Performance Evaluation,” IEEE J. Solid-State Circuits, vol. 24, pp. 256-266, April. 1989.

[3] R. Gaggl, et al., "A 85-dB dynamic range multibit delta-sigma ADC for ADSL-CO applications in 0.18-μm CMOS," IEEE J. Solid-State Circuits, vol. 38, pp. 1105-1114, 2003.

[5] O. Oliaei, P. Clement and P. Gorisse, “A 5-mW Sigma–Delta Modulator with 84-dB Dynamic Range for GSM/EDGE,” IEEE J. Solid-State Circuits, vol. 37, pp. 2-10, Jan. 2002.

[6] K. Vleugels, S. Rabii and B. Wooley, “A 2.5-V Sigma-Delta Modulator for Broadband Communication Applications,” IEEE J. Solid-State Circuits, vol. 36, pp. 1887-1899, Dec. 2001.