超臨界流體熱管（SHP）是使用超臨界流體二氧化碳為工作流體來傳遞熱能之裝置，其無需外加任何機械力，完全靠內部超臨界流體快速循環運動來移熱。
　　本論文主要目的為新式熱管之研發測試，設計了單管型熱管與迴路型熱管兩種之SHP環路。單管型熱管設計了同心圓熱管來解決內部空間的問題；迴路型熱管設計了SLHP-1、SLHP-2、SLHP-3以及SHLP-4四種類型之環路，SLHP-1和SLHP-2為比較環路結構不同，SLHP-3和SHLP-4則是使用不同管徑結合之結構來作比較。迴路式熱管因在結構上折彎較多且接合處過多使得有壓力承受之問題，因此效果不知同心圓熱管。同心圓熱管在CPU加熱瓦數各6瓦時CPU1及CPU2溫度為80.8℃、77.1℃，熱阻值為3.77℃/W、3.46℃/W。本論文亦針對不同加熱途徑及不同系統壓力作探討

目錄
摘要 I
Abstract II
誌 謝 III
目錄 IV
圖目錄 VII
表目錄 XII
第一章 緒論 1
1.1前言 1
1.2 研究動機 3
1.3文獻回顧 4
第二章理論分析與環路設計 8
2.1 工作原理 8
2.2 二氣化碳 10
2.2.1 二氣化碳的特點 10
2.2.2 超臨界二氣化碳應用原理 11
2.3 SHP管路之設計： 13
第三章 實驗設備及方法 22
3.1 實驗前準備工作 22
3.1.1 超音波清洗機(Ultra-sonic cleaner) 22
3.1.2 氣體壓縮機（High pressure shringe pumps） 23
3.2 測試系統 24
3.3實驗方法與步驟 25
3.3.1 SHP性能測試 26
3.3.2 SHP垂直加熱測試步驟 26
3.3.3 SHP水平加熱測試步驟 26
第四章 實驗結果與討論 44
4. 1環路參數定義 44
4. 2垂直式加熱-加熱途徑（A） 49
4.2. 1單管型熱管SHP 49
4.2. 2迴路型熱管SHP 50
4. 3垂直式加熱-加熱途徑（Ｂ） 65
4.3. 1單管型熱管SHP 65
4.3. 2迴路型熱管SHP 66
4. 4水平式加熱 69
4.4. 1同心圓熱管SHP 69
4.4. 2迴路型熱管SHP 70
第五章 結論 90
參考文獻 92

參考文獻
[1] Ｂasiulis, A., and Hummel, T. A., “Development of A Cryosurgical Instrument Utilizing An Open Loop Heat Pipe,” AIAA Paper no.74-750, Torrance, California, 1974.
[2] Seok Hwman Moon, “Experimental Study on the Performance of Miniature Heat Pipes With Woven-Wire Wick”, IEEE Transaction on components and packing technologies,24, No. 4, 1521-3331, December 2001
[3] T. Kaya, R. P□rez, C. Gregori, A. Torres “Numerical simulation of transient operation of loop heat pipes” Applied Thermal Engineering, Volume 28, Issues 8-9, June 2008, Pages 967-974
[4] F. J. Stenger, “Experimental Feasibility Study of Water-Filled Capillary-Pumped Heat Transfer Loop”, NASA TM X-1310, Lewis Research Center, Cleveland, OH, Nov. 1966
[5] E. J. Kroliczek, “Capillary Pumped Loop Heat Pipe Development Status Report”, Report to NASA/GSFC , OAO Corporation, 1982
[6] S. Launay, V. Sartre, J. Bonjour, “Parametric analysis of loop heat pipe operation: a literature review” International Journal of Thermal Sciences 46, pp.621-636, 2007
[7] Hafner, A., Neksa, P. And Pettersen, J.,”LifeCycle Climate Performance (LCCP) of MobileAir-Conditioning Systems with HFC-134a,HFC-152a and R-744”, 15th Annual Earth Technologies Forum and Mobile AirConditioning Summit, Washington, USA,April 13~15, 2004.
[8] 余培煜、張鈺炯、楊錞忠，湯岳儒，洪景華，劉陽光，「二氧化碳冷媒應用於熱泵之關鍵技術開發」，海峽兩岸冷凍空調學術暨技術研討會，A12-1~8 頁，民國96 年12 月。
[9] 余培煜,「使用CO2為工作流體之穿臨界冷凍循環的介紹」,冷凍空調＆熱交換93.9\第62 期, P.20~P27。
[10] 余培煜、楊錞忠,「家用二氧化碳小型熱泵熱水器的開發」,冷凍空調＆熱交換97.11\第87 期, P.9~P19。
[11] J. Yin, Y.C. Park, D. Boewe, R. McEnaney, A. Beaver, C.W. Bullard, P.S. Hrnjak, Experimental and model comparison of transcritical CO2 versus R134a and R410 system performance, in: Proc. of the IIR-Gustav Lorentzen Conference on Natural Working Fluids, Oslo, Norway, 1998, pp. 376–387.
[12] R. McEnaney, D. Boewe, J. Yin, Y.C. Park, C.W. Bullard, P.S. Hrnjak, Experimental comparison of mobile A/C systems when operated with transcritical CO2 versus conventional R134a, in: Proc. International Refrigeration Conference at Purdue, 1998, pp. 145–150.
[13] Sung Chul Kim, Min Soo Kim.” Performance evaluation of a CO2 heat pump system for fuel cell vehicles considering the heat exchanger arrangements ” International Journal of Refrigeration 30 (2007) 1195-1206
[14] Jianlin Yu *, Hua Chen, Hua Zhao, Yanzhong Li.” An experimental investigation on capillary pumped loop with the meshes wick” International Journal of Heat and Mass Transfer 50 (2007) 4503–4507
[15] J. Ku, Overview of capillary pumped loop technology, in: ASMEHTD-vol. 236, Heat Pipes and Capillary Pumped Loops, 1993, pp. 1–17.
[16] Yu.F. Maydanik, State-of-the-art of CPL and LHP technology, in:Heat Pipe Science and Technology, Proc. 11th Int. Heat PipeConference, Tokyo, 1999, pp. 19–30.
[17] 談駿嵩, 「超臨界流體的應用」,科學發展,91.11\第359期,p12~p17。
[18] Introduction of Transcritical RefrigerationCycle Utilizing CO2 as Working Fluid” Haruhisa Yamasaki, Masaji Yamanaka, KenzoMatsumoto and Gaku Shimada, 2004International Compressor EngineeringConference, Purdue University, West Lafayette,Indiana, USA. July 12-15, 2004.
[19] 林育安,林鴻文,黃朝揚,林唯耕,“毛細泵吸環路冷凝部溫度分佈理論預測”,中國機械工程學會第二十四屆全國學術研討會,中華民國九十六年十一月二十三日、二十四日,中壢,台灣(NSC-95-2221-E-007-117)
[20] H. W. Lin, Y. A. Lin, W. K. Lin, “Evaluation of Condenser Transient Heat Transfer Behavior of the Small Scale Capillary-Pumped Loop”, ASME-JSME Thermal Engineering and Summer Heat Transfer Conference, Vancouver, BC, Canada, July,8-12, 2007. (EI)