一個採用預測電壓遲滯控制技術來達到快速暫態響應之直流降壓式轉換器

A Hysteresis Prediction Voltage Control Technique for Fast Transient Response in DC-DC Converters

賴佑旻(You-Min Lai)

指導教授 ： 陳信樹

國立臺灣大學/電機資訊學院/電子工程學研究所/碩士(2013年)

https://doi.org/10.6342/NTU.2013.02137

摘要

本論文闡述一個預測電壓遲滯控制技術來達到降低暫態突波以及快速暫態響應的直流電壓轉換器，這個技術使用做在晶片裡面的雙級錯誤放大器補償方式作為穩態控制，而當暫態發生的時候會切換預測電壓遲滯控制來加快反應，這個晶片以台積電0.35-μm 2P4M 3.3V/5V Mixed Signal CMOS製程製作。由分析以及模擬結果可以看出，傳統控制的暫態突波相當大，回復時間也需要很久，使用本技術後則會得到不錯的改善。
依據量測的結果，因為受到輸出電壓的高頻突波影響，遲滯預測控制的部分功能會發生錯誤而無法運作。只使用雙級錯誤放大器的暫態回復時間可以改善到25 μs，本晶片切換頻率操作在1 MHz，當輸出電流為190 mA時得到最高效率87%。晶片面積包含on-chip補償總共占1.518 × 1.643mm2，而其它的量測結果也包含在本論文內。

關鍵字

直流轉換器 ； 快速暫態響應 ； 遲滯控制

並列摘要

This paper presents a hysteresis prediction voltage control (HPVC) method using the predictive strategy with early operations to reduce the transient ripple and minimizes the transient time in dc-dc converter. This HPVC control is composed of on-chip compensated two-stage EA PWM for steady-state PWM control. During transient, the buck converter switches to the HPVC mode to speed up the transient response. This technique is implemented in a standard 0.35-μm 2P4M 3.3V/5V Mixed Signal CMOS process. The analysis and simulation show that without using the HPVC technique in typical PWM dc-dc converter, the transient ripple is larger in magnitude and the transient time is lengthening. After the HPVC technique is applied, the prediction circuit will estimate the variation of voltage that is going to change by detect the capacitor current any time. In this way, the transient ripple can be greatly decreased and the transient time is also reduced.
According to the measurement results, the function of HPVC control failed because of the spike of output voltage. The measurement shows that the recovery time can be improved to 25 μs by using the two-stage EA PWM compared to conventional PWM. The switching frequency of the chip operates at 1MHz, and the maximum efficiency is 87% when load current is 190 mA. The total chip area with on-chip compensated components is 1.518 × 1.643 mm2, and the other detailed measurement is included in this thesis.

並列關鍵字

DC-DC Converter ； Fast Transient Response: Hysteresis Control

參考文獻

[2] H. W. Whittington, B. W. Flynn and D. E. Macpherson, “Switched Mode Power Supplies: Design and Contruction, ” John Wiley & Sons, 1992.

[3] D. D. Lu , J. C. Liu , N. K. Poon and M. H. Pong “A single phase voltage regulator module (VRM) with stepping inductance for fast transient response,” IEEE Trans. Power Electron., vol. 22, pp.417–424, Mar., 2007.

[4] P. J. Liu, Y. K. Lo , H. J. Chiu and Y. J. Chen “Dual-current pump module for transient improvement of step-down DC-DC converters”, IEEE Trans. Power Electron., vol. 24, no. 4, pp.985 -990, April, 2009.

[5] W. J. Lambert, R. Ayyanar, and S. Chickamenahalli “Fast load transient regulation of low-voltage converters with the low-voltage transient processor,” IEEE Trans. Power Electron., vol. 24, no. 7, pp.1839 – 1854, July, 2009.

[6] J. Roh “High-performance error amplifier for fast transient DC-DC converters,” IEEE Trans. Circuits Syst. II, Exp. Briefs, vol. 52, pp.591 – 595, Sept., 2005.