奈米晶粒矽 P-I-N 太陽能電池

Nanocrystalline Si P-I-N Solar Cell

黃益韋(Yi-wei huang)

指導教授 ： 洪志旺

國立中央大學/資訊電機學院/電機工程學系/碩士(2007年)

摘要

本論文主要目的是研製奈米晶粒矽 (nc-Si:H) p-i-n 太陽能電池。首先是利用四種不同的製程方法製備所要的nc-Si:H薄膜: (1)在PECVD系統的陰極加裝不銹鋼網； (2) 先在基板上成長一層a-Si:H緩衝層，再沉積nc-Si:H薄膜； (3) 先使用氫電漿處理a-Si:H緩衝層後，再沉積nc-Si:H薄膜； (4) 用氫氣稀釋源氣體SiH4的方式沉積nc-Si:H薄膜。我們也使用微拉曼光譜儀 (micro-Raman spectroscopy)、X光繞射儀 (XRD) 及場發射掃描式電子顯微鏡(FE-SEM) 等儀器分析各nc-Si:H薄膜的結晶度。測量結果顯示，先在基板上沉積一層緩衝層，再用氫電漿處理緩衝層的表面，而後配合適當的SiH4濃度，可沉積出較佳的矽奈米晶粒 (nc-Si:H) 薄膜。
再者，我們也利用上述較佳的製程參數，製備了二種不同結構的太陽能電池並量測其短路電流、開路電壓、填充因子及轉換效率。第一個元件的結構是Al / n-a-Si:H / i-a-Si:H / p-a-SiC:H / ITO /glass，另一個元件的結構為Al / n-a-Si:H / i-nc-Si:H / i-a-Si:H ( buffer layer )/ i-a-Si:H / p-a-SiC:H / ITO /glass。實驗結果顯示，在AM1.5之下，前者有比較好的轉換效率 (1.08%) ，而後者具略高的填充因子 (0.278)。

關鍵字

太陽能電池 ； 奈米晶粒矽

並列摘要

In this thesis, the fabrication process and performance of the nanocrystalline silicon (nc-Si) p-i-n solar cells was studied. Firstly, the nc-Si:H films were deposited with a PECVD (plasma-enhanced chemical vapor deposition) system, by employing four different process techniques: (1) attaching a stainless steel mesh to cathode of the PECVD system, (2) an a-Si:H buffer layer was deposited on the substrate before growing the nc-Si:H film, (3) applying additional in-situ H2-plasma treatment on the a-Si:H buffer layer before growing the nc-Si:H film, and (4) the SiH4 reaction gas was diluted in H2 ,and the crystallinity of the obtain films were compared. The nc-Si:H films were characterized with micro-Raman spectroscopy, X-ray diffraction (XRD) and field-emission scanning electron microscope (FE-SEM). From the measurment results, it was concluded that depositing an a-Si:H buffer layer and then applying in-situ H2-plasma treatment on a-Si:H buffer layer could result in the better crystallinity of the grown nc-Si:H film.
Then, two different structures of nc-Si:H p-i-n solar cell were fabricated and their characteristics such as the short-circuit current ( Isc ), open-circuit voltage ( Voc ),fill factor ( FF )and efficiency ( eff. ) were measured. For the device structures, one was Al / n-a-Si:H / i-a-Si:H / p-a-SiC:H / ITO (indium tin oxide) /glass and the other was Al / n-a-Si:H / i-nc-Si:H / i-a-Si:H ( buffer layer )/ i-a-Si:H / p-a-SiC:H / ITO /glass. The measured results showed that the former one had a higher efficiency (~ 1.08%) and the later one had a little higher FF (~ 0.278) under AM1.5.

並列關鍵字

Nanocrystalline Si ； Solar Cell

參考文獻

[2] C. I-Chun and W. Sigurd, “High hole and electron field effect mobility in Nanocrystalline silicon deposited at 150 ℃,” Thin Solid Films, Vol. 427, pp. 56-59 (2003).

[3] Y. T. Tan, T. Kamiya, Z. A. K. Durrani, and H. Ahmed, “Room temperature nanocrystalline silicon single-electron transistors,” Journal of Applied Physics, Vol. 94, pp. 633-637 (2003)

H film and its application to solar cells,” Jpn. J. Appl. Phys., Part 2, Vol. 21, pp. L586 (1986)

[5] J. Nelson, “The physics of solar cells,” Imperial College Press, pp. 249 (2003).

[7] Y. Yamamoto, S. Suganuma, M. Ito, M. Hori, and T. Goto, “Effects of dilution gases on Si atoms and SiHx + (x = 0–3) ions in electron cyclotron resonance SiH4 plasmas,” Jpn. J. Appl. Phys., Part 1, Vol. 36, pp. 4664 (1997)