以RGB LED為投影顯示光源之光學性能研究

The study of porjection display using RGB LED as light source

韓明媛(Ming-yuan Han)

指導教授 ： 孫慶成

國立中央大學/理學院/光電科學研究所/碩士(2008年)

摘要

本論文主要是在探討以LED為投影機光源時，其收光元件利用複合式拋物面收光器(Compound Parabolic Concentrator，簡稱CPC)原理之設計流程，並使用此流程找出最佳化之收光設計，並實際製作出收光元件，再搭配LED晶片封裝成收光模組。最後將此收光模組應用於市售投影機之光機系統，分析其輸出、系統效率及均勻性

關鍵字

液晶 ； 投影顯示 ； 發光二極體

並列摘要

In this thesis, we study to optimize the optical system with RGB LEDs. We start from the design of the compound parabolic concentrator to collect the light from LEDs and maintain the etendue requested by the optical system. At the same time, we simulate the optical distribution with specific LED arrangement. We compare the experimental measurement with the simulation and finally design an optical module for the LED projection system, where the system efficiency as well as uniformity are analyzed.

並列關鍵字

projection display ； RGB LED ； LCD

參考文獻

[1] N. Holonyak, Jr. and S. F. Bevaqua, “Coherent(visible) light emission from Ga(As1-xPx) junctions,” Appl. Phys. Lett. 1, 82 (1962).

[2] M. G. Craford, “LEDs for solid state lighting and other emerging applications: status, trends, and challenges,” Proc. SPIE 5941, 1-10 (2005).

[4] Y. Oana, “Technical development and trends in α-Si TFT LCDs ,” J. Non-Cryst. Solids, 115, 27-32 (1989).

[5] L. J. Hornbeck, “128*128 deformable mirror device,” IEEE Trans. Elect. Dev, 30, 539-545 (1983).

[6] D. J. McKnight, K. M. Johnson, and R. A. Serati, “256 by 256 liquid-crystal-on-silicon spatial light modulator,” Appl. Opt. 33, 2775-2784 (1994).