含功能性支承縮尺橋梁之試驗與分析

Seismic Behavior of Reduced Scale Bridge Models with Functional Bearings

陳威逸(Wei-I Chen)

指導教授 ： 張國鎮

國立臺灣大學/工學院/土木工程學研究所/碩士(2007年)

https://doi.org/10.6342/NTU.2007.00937

摘要

本文旨在討論含功能性支承橋梁於地震下的行為。有鑑於國內現行橋梁耐震設計規範及修復補強策略，多偏重於橋柱塑鉸行為，但921集集大地震中並無明顯實例可供參考，若需符合規範要求，則政府單位須編列高額的橋梁補強經費。因此，本文由縮尺橋梁靜動態實驗與分析結果，探討橋梁使用功能性支承的成效。
本研究首先完成含橡膠支承縮尺單跨橋梁之擬動態與振動台實驗，根據實驗結果了解橋梁結構之力量傳遞路徑，並探討兩種試驗方式對描述橋梁動態行為的差異性。此外，本研究中採用非線性分析工具（SAP2000N）進行模擬，經實驗結果比對可獲致良好的結果，並針對磨擦係數與混凝土楊氏係數進行參數分析，量化支承滑動與橋柱勁度的影響。
為進一步了解多跨橋梁的動態行為，本研究執行含橡膠支承縮尺雙跨橋梁之振動台實驗。結果顯示，橡膠支承發生滑動後可降低橋面版加速度及橋柱剪力，有助於降低下部結構震害受損機會。因此，本研究建立合適的分析模型，能有效預測橋面版之最大位移與最大加速度反應，掌握落橋及橋柱損壞時機。

關鍵字

功能性支承系統 ； 橡膠支承 ； 磨擦係數 ； 擬動態實驗 ； 振動台實驗

並列摘要

Study on the seismic behavior of the bridge with functional bearings is presented in this thesis. In Taiwan, only a few studies draw attention on the bearing until 1999 Chi-Chi earthquake. Before that researchers are putting much effort on the bridge column to minimize damages under large ground motion, according to the specification of seismic design of Highway bridges or seismic retrofit manual. However, with small amount of retrofitted bridges being proved available in the earthquakes and limited national budget placed on the retrofitting plan of bridges, it is important to provide an economical approach by entitling appropriate function to the bearing system. In this study, two experimental programs were carried out to understand friction/sliding mechanism for the bridge equipped with rubber bearing and PTFE-rubber bearing. Firstly, by examining the performance of same reduced-scale single span bridge from both pseudo-dynamic test and shaking table test, it is found the loading path from superstructure to substructure well satisfies the relationship of force balance at anytime, no matter the bridge is sliding or not. Meanwhile, sliding of bearing contributes a fuse-like function to protecting columns from suffering large shear force. The major difference of obtaining structure responses via those two methods is due to the velocity-related behavior of friction coefficient, giving a conservative estimation of force from the shaking table test and displacement from pseudo-dynamic test, respectively. In addition, analytical results by utilizing SAP2000N are well satisfied with the experimental data. It is useful to perform a better parametric analysis when dealing with friction coefficient and the Young’s Modulus of concrete. The behavior of a reduced-scale two spans bridge with rubber bearings in the shaking table test was introduced in the second part of the study. From experimental data and analytical results, it can be found that the sliding of bearing could reduce the demand of inertial force of the girder, as a function of isolation by which the column shear force is largely reduced in the comparison of that from using an ideal hinge- and-roller bearing simulation. Finally, the proposed analytical model is useful to predict the maximum displacement. It is convenient to check the unseating length to avoid falling in a practical manner.

並列關鍵字

functional bearing system ； rubber bearing ； frictional coefficient ； pseudo-dynamic test ； shaking table test

參考文獻

陳皇嘉（2005），“裝設橡膠支承墊於橋梁縮尺模型之試驗與分析”，國立台灣大學土木工程學研究所碩士論文，張國鎮教授指導。

廖垣銓（2006），“裝設橡膠支承墊於縮尺雙跨橋梁模型之試驗與分析”，國立台灣大學土木工程學研究所碩士論文，張國鎮教授指導。

劉光晏（2006），“橋梁功能性支承系統耐震性能設計與評估補強方法之研究”，國立台灣大學土木工程學研究所博士論文，張國鎮教授指導。

王孔君（1997），“即時擬動態試驗研究”，國立台灣大學土木工程學研究所碩士論文，蔡克銓教授、張順益博士指導。

張國鎮、吳秉憲、劉光晏（2004），“橋梁功能性支承系統參數之研究－橡膠支承墊力學行為與摩擦係數之測定”，報告編號：NCREE-04-027，國家地震工程研究中心。