透過您的圖書館登入
IP:3.149.233.6
  • 學位論文

摻雜氧化鎂鈮酸鋰準相位匹配大溫度頻寬綠光倍頻雷射晶片研製

Quasi-Phase-Matching Second Harmonic Generation Green Laser with Large Temperature Bandwidth On PPMgO:LiNbO3

指導教授 : 彭隆瀚

摘要


本篇論文主要以摻雜氧化鎂鈮酸鋰為材料,研製週期性極化反轉倍頻雷射晶片,目標為利用此晶片達成輸入1064nm紅外光準相位匹配倍頻產生532nm綠光。 製程部分以未摻雜共熔鈮酸鋰(CLN)高電壓致極化反轉經驗為基礎加以改良,在厚度為0.5um摻雜氧化鎂鈮酸鋰(MgO:LN)晶片成功研製出最小週期為6.91um第一階一維和多週期第一階一維週期性結構;在厚度為1um摻雜氧化鎂鈮酸鋰(MgO:LN)晶片也成功研製出13.8um第二階一維及6.94um第一階準一維的週期性結構。 光學實驗部分只對0.5um厚摻雜氧化鎂鈮酸鋰(MgO:LN)晶片做討論。單週期結構、長度5um,以170MW/cm2(180mW) 光腰半徑60um奈秒泵浦條件下,產生80mW的綠光輸出、轉換效率約在46%;並在區段啁啾結構設計下,於多週期結構、長度5um,以195MW/cm2(350mW)光腰半徑75um之奈秒泵浦條件下,產生63mW的綠光輸出,轉換效率約20%,且可接受溫度頻寬達50度。相較於同樣長度單週期設計,雖然轉換效率降低了2.3倍,但提升了10倍的可接受溫度頻寬。

並列摘要


This thesis reports the fabrication of periodically poled magne-sium-oxide-doped congruent lithium niobate (PPMgLN), to convert the 1064nm infrared laser into 532nm green light by using the technique of quasi-phase matching second harmonic generation(QPM-SHG). We improved the fabrication technique on electric poling method of congruent lithium niobate. This method leads to the realization of periodically poled QPM structures on 0.5mm and 1mm thick MgO:LiNbO3 substrates. The smallest periods achieved in this work are (i) 6.91um for the 1st - order 、(ii) chirped-gratings for the 1st-order QPM device. For the 1mm thick substrate , the smallest periods we can make are (i) 6.96um for the 1st-order quasi-1D、(ii)13.8um for the 2nd–order QPM device. For the characterization we measured SHG on PPMgLN with 5mm crystal length when pumped by a pulsed 1064nm laser of 159 MW/cm2 (180mW) with 5ns pulse width of 60um beam waist. The device exhibits 80mW green light output with conversion efficiency attain 46% . Second, the design of chirped grating structure with 5mm long are tested by a pulsed 1064 nm laser of 195 MW/cm2 (350mW) with beam radius 75um. The device exhibits 63mW green light output with the conversion efficiency 20%, and the acceptance temperature bandwidth is about 50 degree. In the same length, the acceptance temperature bandwidth for the segment-chirped design exceeds that of single period by a factor of 10, whereas the conversion efficiency is reduced only by a factor of 2.3 .

參考文獻


32 陳逸豪, “利用鈮酸鋰一維非線性光子晶體產生光參共振可調波長雷射光源之研究,” 國立台灣大學光電工程學研究所碩士論文, 2006
34 林立峰, “摻氧化鋅鈮酸鋰二維非線性光子晶體之研究,”國立台灣大學光電工程學研究所碩士論文, 2005
27 溫建樹, “寬頻準相位匹配非線性過程應用於綠光與藍光產生之研究,”台灣大學光電工程學研究所碩士論文, 2010
21 李俊瑩, “摻雜氧化鎂鈮酸鋰之準相位匹配綠光倍頻雷射晶片研製,”國立台灣大學光電工程學研究所碩士論文, 2009
30 林威呈, “利用高介電係數材料與高溫製程作二維非線性光子晶體,”國立台灣大學光電工程學研究所碩士論文, 2004

被引用紀錄


楊鈞皓(2014)。鉭酸鋰非線性光子晶體與鎳擴散波導之黃光雷射產生研究〔碩士論文,國立臺灣大學〕。華藝線上圖書館。https://doi.org/10.6342/NTU.2014.01917
許翰棕(2013)。級聯準相位匹配光學參量與倍頻效應之扇形週期性極化反轉鉭酸鋰寬頻藍光雷射晶片之研究〔碩士論文,國立臺灣大學〕。華藝線上圖書館。https://doi.org/10.6342/NTU.2013.01548
楊宇軒(2012)。多週期極化反轉鈮酸鋰帶狀波導綠光雷射晶片之研製〔碩士論文,國立臺灣大學〕。華藝線上圖書館。https://doi.org/10.6342/NTU.2012.02640
謝孟軒(2011)。摻雜氧化鎂鈮酸鋰之帶狀波導大溫度頻寬綠光雷射晶片之研製〔碩士論文,國立臺灣大學〕。華藝線上圖書館。https://doi.org/10.6342/NTU.2011.10372
周志賢(2011)。準相位匹配鉭酸鋰高效率寬頻藍光雷射晶片之研製〔碩士論文,國立臺灣大學〕。華藝線上圖書館。https://doi.org/10.6342/NTU.2011.03120

延伸閱讀