不銹鋼爐碴量對CLSM材料抗壓強度之影響

Compressive Strength of Controlled Low Strength Materials Containing Stainless Steel Slag

沈永年(Y. N. Sheen) ； 孫德和(T. H. Sun) ； 鍾文豪(W. H. Chung)

《防蝕工程》 22卷3期 (2008/09) Pp. 217-229

https://doi.org/10.6376/JCCE.200809.0217

摘要

本研究係探討以氧化碴取代細骨材及以還原碴取代膠結料，對高流動性低強度材料(CLSM)之強度發展影響。研究變數包括水膠比爲1.1、1.3與1.5；CLSM膠結料固定爲130kg/立方公尺；還原碴取代膠結料比例爲0%、25%及50%，一般型CLSM之氧化碴取代細骨材比例爲0%、50%、75%及100%，早強型CLSM之氧化碴取代細骨材比例爲0%、50%及100%。研究結果顯示，利用氧化碴與還原碴可製作出坍度大於20cm、28天齡期抗壓強度小於30kg/平方公分之CLSM材料。當氧化碴取代細骨材比例愈高時，不銹鋼爐碴CLSM之超音波波速亦愈高，並且凝結時間相對減少。不銹鋼爐碴CLSM之還原碴取代膠結量愈高時，其凝結時間愈長，而超音波波速與抗壓強度則相對降低。

關鍵字

不銹鋼氧化碴 ； 不銹鋼還原碴 ； CLSM ； 抗壓強度

並列摘要

The purpose of this research is to determine the compressive strength of the Controlled Low Strength Materials (CLSM) containing both the Stainless Steel Oxidizing Slag (SSOS) and the Stainless Steel Reducing Slag (SSRS). The test variables include the general type (28-day compressive strength ＜30kg/cm^2) and the early type (1-day compressive strength ＞5kg/cm^2). The binder amount is 130 kg/m^3, and water to binder ratio (W/B) are 1.1, 1.3 and 1.5. The weight ratios of SSOS replacing the fine aggregate are 0%, 50%, 75% and 100%. The weight ratios of the SSRS replacing the binder are 0%, 25%, and 50%. The results show utilizing SSOS and SSRS can produce CLSM which slump larger than 20 cm. The compressive strength of 28 days of CLSM consists of the Stainless Steel Slag less than 30 kg/cm^2. As the SSOS replace the fine aggregate more, the unit weight and pulse velocity of CLSM raise, but the setting time reduce. As the SSRS replace the binder more, the pulse velocity and the compressive strength of CLSM reduce, but the setting time of CLSM increase relatively.

並列關鍵字

SSOS ； SSRS ； CLSM ； Compressive strength