透過您的圖書館登入
IP:18.223.20.57
  • 期刊
  • OpenAccess

Source Apportionment of Total Suspended Particulate Matter in Coarse and Fine Size Ranges Over Delhi

並列摘要


Source apportionment of total suspended particulate matter (TSPM) and associated heavy metals has been carried out for the city of Delhi using the Chemical Mass Balance Model, Version 8 (CMB8), as well as principle component analysis (PCA) of SPSS (Varimax Rotated Factor Matrix method) in coarse-and fine-size mode. Urban particles were collected using a five-stage impactor at six sites in the winter of 2005-06. The impactor segregates the TSPM into five different size ranges (viz.>10.9, 10.9-5.4, 5.4-1.6, 1.6-0.7 and <0.7 µm). Four samples were collected from six different sites every 24 hours. Samples were analyzed in five size ranges gravimetrically and chemically for the estimation of SPM and metals. The five different size ranges were divided into two broad categories: coarse (1.6 to>10.9 µm) and fine (<1.6 µm). The CMB8 and PCA were executed separately for both coarse and fine size ranges. Results obtained by CMB8 indicate the dominance of vehicular pollutants (62%), followed by crustal dust (35%) in the fine size range; while in the coarse size range crustal dust dominated (64%) over vehicular pollution (29%). Little contribution from paved-road dust and industrial sources was observed. Results of PCA (or factor analysis) reveal two major sources (vehicular and crustal re-suspension) in both coarse and fine size ranges. The correlations of factors (sources) with the metals show that in the coarse size range the dominant source is crustal re-suspension (68%) followed by vehicular pollution (23%). However, this is reversed in the case of the fine size range factor analysis where vehicular pollution (86%) dominated over crustal re-suspension (10%).

被引用紀錄


Huang, Y. S. (2011). Demand-Driven Disassembly Plan for a Robust Closed-Loop Supply Chain System [master's thesis, National Tsing Hua University]. Airiti Library. https://doi.org/10.6843/NTHU.2011.00160
莊惠芳(2006)。氧化銦錫奈米線製備及單根奈米線電性研究〔碩士論文,國立清華大學〕。華藝線上圖書館。https://doi.org/10.6843/NTHU.2006.00359
Chang, I. C. (2014). 影響顧客使用行動銀行意願關鍵因素 [master's thesis, National Chiao Tung University]. Airiti Library. https://doi.org/10.6842/NCTU.2014.00499
楊勁生(2009)。氧化銦錫奈米柱狀結構應用於提升氮化鎵發光二極體之出光效率〔碩士論文,國立交通大學〕。華藝線上圖書館。https://doi.org/10.6842/NCTU.2009.00557
吳智忠(2012)。磁控濺鍍鉻鋁矽氮化物薄膜於鋁合金壓 鑄用模具鋼上之製程探討與性質研究〔碩士論文,國立臺北科技大學〕。華藝線上圖書館。https://doi.org/10.6841/NTUT.2012.00532

延伸閱讀