- 期刊
低壓射蠟快速模具研製與應用
Fabrication and Application of Low-Pressure Wax Injection Rapid Toolings
並列摘要
This paper proposed a method for fabricating silicone rubber molds for low-pressure wax injection molding. The wax spilling is one of the most troublesome problems during wax injection molding process. From the point of view of green manufacturing, the optimal processing conditions in the wax injection molding process were investigated using Taguchi method. The experimental results revealed that the most influential factor affecting the weight of spilled wax during wax injection molding process is the injection time. The optimal processing conditions in the wax injection molding process are injection temperature of 82 ℃, injection time of 2 sec, injection pressure of 0.6 kgf/cm2 and mold temperature of 60℃.
延伸閱讀
- 郭啟全、蘇聖傑（2013）。精密低壓射蠟模具快速製造技術之開發。建國科大理工期刊，32(2)，21-49。https://www.airitilibrary.com/Article/Detail?DocID=P20110518002-201304-201305140010-201305140010-21-49
- 莊岱融（2011）。PDMS環模結合氣囊滾輪複製UV樹脂微奈米結構製程的研發及應用〔碩士論文，國立臺灣大學〕。華藝線上圖書館。https://doi.org/10.6342/NTU.2011.02408
- Luo, R. C., & Tzou, J. H. (2007). 直接金屬快速模具系統應用於射出成型模具. 中國機械工程學刊, 28(2), 149-156. https://doi.org/10.29979/JCSME.200704.0004
- 郭啟全、許修繻（2013）。繞射光學元件精密快速模具研製。建國科大理工期刊，32(2)，83-100。https://www.airitilibrary.com/Article/Detail?DocID=P20110518002-201304-201305140010-201305140010-83-100
- 蔡聲鴻（2005）。Fabrication and Analysis on Heat Spreaders〔博士論文，淡江大學〕。華藝線上圖書館。https://doi.org/10.6846/TKU.2005.00122