Numerical Calculation of Internal Force of Segment Lining in Shield Tunnel

Wenli Lv ； Jie Jiang ； Xinyu Liu ； Liang Liu

《International Core Journal of Engineering》 8卷5期 (2022/05) Pp. 255-267

https://doi.org/10.6919/ICJE.202205_8(5).0031

摘要

Combined with the example data of Xihe shield tunnel project, taking numerical simulation as the main means, the mechanical model of segment lining of shield tunnel for oil and gas pipeline is constructed by using load structure model in structural calculation. Four segments with different thicknesses of 300mm, 250mm, 200mm and 100mm are selected for numerical simulation calculation, and the deformation diagram and internal force diagram of shield tunnel segment lining under the same load are obtained. The numerical simulation results show that when the segment thickness changes, the deformation and internal force also increase or decrease. The safety conditions of 8 typical points on the lining structure are checked and calculated by limit state method and allowable stress method. It is found that it is unsafe to use 100mm thick segment lining, and the 250mm thick segment used in the actual project meets the requirements.

關鍵字

Tunnel Engineering ； Numerical Simulation ； Load Structure Model ； Segment Internal Force

參考文獻

Duddeck H, Erdmann J. Structural design models for tunnels[J]. International Journal of Rock Mechanics and Mining Science & Geomechanics Abstracts, 1985, 9:5-6(5).

HB Henry. Shield and Compressed Air Tunneling[J]. McGraw-Hill, 1922.

Schmidt B. TUNNEL LINING DESIGN - DO THE THEORIES WORK?[J]. deposits, 1984.

Scordelis A C. A rational method of analysis of the stresses in linings of shield-driven tunnels /.

Translated by Yang Shizhong. About the design of circular tunnel. Tunnel translation,1979.04.