氧化錫螢光材料之製備與特性分析

Preparation and Characterization of Tin Oxide Phosphors

李承道(Cheng-Tao Lee)

指導教授 ： 呂宗昕

國立臺灣大學/工學院/化學工程學研究所/碩士(2008年)

https://doi.org/10.6342/NTU.2008.00790

摘要

摘要

本研究成功利用微波水熱法製備氧化錫(SnO2)之螢光材料，並調整各種實驗參數來觀察其對螢光粉體所造成之影響。在本論文第一部份中，使用釤(Sm3+)作為激發中心並以微波水熱法合成出球形之螢光粉體。所得之前驅物經過煆燒後進行粉體型態與光譜之分析。在波長318 nm處觀察到一個由主體產生之寬廣吸收峰;而560-700 nm的放射峰則屬於釤離子之f-f能量傳遞。實驗中調整釤離子濃度，發現其發光強度隨著釤濃度上升而增加，但超過一定值後會因為雜項生成而降低發光強度。另外當使用之微波瓦數升高時，尿素分解速率增加導致成核數目上升，因此粉體粒徑減小;而螢光強度也會因表面缺陷增加而隨之下降。
在本研究的第二部分使用微波水熱法製備銪離子摻雜之氧化錫螢光粉體。首先探討使用不同溶劑對於粉體之型態及螢光強度所形成之影響，發現以乙醇為溶劑可合成出球型粉體，使用水或是混合溶劑所合成的粉體則成不規則狀。由於圓形粉體具有較低之光散射性，因此發光強度較高。氧化錫放射的橘紅色螢光，主要由銪離子價電子經過5Do-7F1之能傳遞造成。在本實驗中亦調整尿素濃度，發現當濃度增加時，由於溶液之pH值上升，因此銪離子可以較完整的沉澱，使發光強度提升。

關鍵字

氧化錫 ； 螢光粉 ； 微波水熱

並列摘要

Spherical Sn1-xO2: Sm phosphors were successfully synthesized via a microwave-assisted solvothermal route. A broad excitation band ascribed to the host absorption was observed at 318 nm. The prepared phosphors had several emission peaks at 560-700 nm assigned to f-f transition of Sm3+. The emission intensity of Sn1-xO2: Sm phosphors was increased with increasing the concentration of Sm3+ up to x = 0.9%. When the concentration of Sm3+ was further increased, the emission intensity was reduced due to the formation of an impurity phase. As the power of microwave increased, the particle size was reduced because of the increase in the number of nuclei. The luminescence intensity of the phosphors was slightly decreased with increasing the applied power due to an increase in surface defects.
SnO2: Eu3+ phosphors were successfully synthesized via a microwave -assisted solvothermal route. The solvents used were found to have significant effects on the morphology and the luminescent properties of the obtained phosphors. Using ethanol as a solvent resulted in the formation of spherical phosphors with enhanced luminescent intensity. SnO2: Eu3+ phosphors exhibited a reddish-orange emission under excitation at 314 nm, and displayed a broad excitation band in the range of 240-370 nm due to the host absorption. In the microwave irradiation process, increasing the concentration of urea resulted in complete precipitation of Eu3+ ions, thereby enhancing the luminescent intensity.

並列關鍵字

tin oxide ； phosphor ； microwave-hydrothermal

參考文獻

[1] G. Blasse, Luminescence Materials, ed. B. C. Grabmaire. Springer, Berlin, 1994.

[3] Y. Du, M. S. Zhang, J. Hong, Appl. Phys. A-Mater., 76 (2003) 171-176.

[4] T. Gao, T. H. Wang, Mater. Res. Bull., 43 (2008) 836-842.

[10] Y. Wan, J. Y. Lee, J. Power Sources, 144 (2005) 220-225.

[12] K. S. Tun, M. Gupta, Compos. Sci. Technol., 67 (2007) 2657-2664.