建構組織培養苗量產植物工廠之研發

Development of a Plant Factory for the Mass Production of Tissue Culture Plantlets In Vitro

賴建洲(Chien-Chou Lai)

指導教授 ： 張森富

國立臺灣大學/生物資源暨農學院/生物產業機電工程學研究所/博士(2004年)

https://doi.org/10.6342/NTU.2004.10366

摘要

摘要
針對康乃馨與玄蔘，使用不同瓶封口材質之研究證實提高組培瓶內、外氣體交換率(E)，可解決芽體增殖時玻璃質化之問題，更能提高芽體生長之品質。玄蔘芽體增殖數目因E值提高而減少之問題，可透過啟動氣體交換之時機點來解決，例如使用4層藥包紙包覆組織培養瓶口，再以2層石蠟膜(Parafilm)緊密封住瓶口的栽培模式中，於4週後將石蠟膜移除，如此可以產生無玻璃質化、高品質、高數目之芽體。
除了培養基調製、裝填與殺菌作業之機械化、自動化及配合移植作業之生產動線安排之外，廠內使用活動式多層立體床架可提高單位土地面積上之種植面積達13倍，床架配備往復式自走光照裝置更可降低一半之光照設備成本。低成本之風扇水牆設施不但可降低培養室內溫度，更可提高組培瓶內外氣體交換率。一間具高產能、低成本的組織培養苗量產植物工廠已建構完成，正進行商業量產中。
高亮度發光二極體作為組培苗人工光源具發展潛力，交流供電全紅光適用於彩色海芋(Black Magic)組培苗栽培。
關鍵詞:植物工廠、組織培養、發光二極體

關鍵字

植物工廠 ； 組織培養 ； 發光二極體

並列摘要

Abstract
Increasing gas exchange rate (E) of the TC vessel can reduce the vitrification problem frequently found in carnation (Dianthus caryophllus L. cv. Opale) shoot tip culture and adventitious buds production of Scrophularia yoshimurae. More over, higher quality of carnation shoot tip can be produced by increasing E value was found. Problem of decreasing buds counts when increasing E value can be solved by the control on the timing to initiate the gas exchange process. When 4 layers of dispense paper covered with 2 layers of parafilm was used, the highest buds count and best quality buds with no vitrification occurred can be derived if the timing to remove the parafilm to initiate the gas exchange process is set at the 4th week after transplanting.
Besides the design and installation of the transplanting room and the production line for the preparation of cultural media, filling, and sterilization of TC vessels, a 2 floors production building has been established. Within the building, movable multi-layer benches equipped with retractable light mounting fixture were installed which can increase 13 times planting area per unit land area and cost down half of the light. Fan and pad system was used to not only remove the extra thermal energy but also increase the exchange rate of gas inside and outside vessels. A high productivity and low cost plant factory for the mass production of tissue culture (TC) plantlets has been established and is currently under commercial operations.
High intensity light-emitting diode (LED) is the promising light source for TC operations. Providing with alternate current (AC), red LEDs alone can be used to grow TC plantlets of Calla Lily (Black Magic).

KEYWORD: Plant Factory, Tissue Culture, LED

並列關鍵字

Plant Factory ； Tissue Culture ； LED

參考文獻

方煒。1994。水牆設計與使用。農業機械學刊 3(4): 57-70。

古新梅、蔡新聲。1994a。培養基組成分對康乃馨試管苗玻璃質化的影響。中華農業研究 43(1) : 51-62。

古新梅、蔡新聲。1994b。繼代培養對康乃馨試管苗玻璃質化的影響。中華農業研究 43(3) : 308-319。

Jao, R.C. and W. Fang. 2004a. Effects of frequency and duty ratio on the growth of potato plantlets in vitro using light emitting diodes. HortScience 39(2):375-379.

Adkins, S.W. 1992. Cereal callus cultures: control of headspace gases can optimize the conditions for callus proliferation. Aust. J. Bot. 40: 737-749