運用NURBS曲線插補於凸輪研磨之路徑規劃

Using NURBS Interpolation for Grinding Path of Cam Profile

黃仁志(Ren-Zhi Huang)

指導教授 ： 康淵

中原大學/工學院/機械工程研究所/碩士(2003年)

https://doi.org/10.6840/cycu200300708

摘要

摘要
本文將根據自由型曲線理論所發展的NURBS(Non-Uniform Rational B-Spline)插補技術，探討凸輪輪廓研磨之路徑。以NURBS方法重建凸輪輪廓，規劃出研磨凸輪之加工模組，並將此加工程式透過FANUC控制器之連結與執行，實現以NURBS方法研磨凸輪輪廓之實際加工路徑控制。

關鍵字

曲線插補 ； 控制器 ； NURBS ； 凸輪研磨

並列摘要

Abstract
This study presents a method and module, which for scheme a grinding path of cam profile according to NURBS method, and we show that, can be to connect with the FANUC controller, and make it feasible to control the grinding path of cam profile.

並列關鍵字

cam grinding ； controller ； NURBS ； curve interpolation

參考文獻

2. L. Piegl, “On NURBS: A Survey,” IEEE Computer Graphics and Applications, Vol. 19, No. 1, pp.55-26, 1991.

4. G. Farin, “From Conics to NURBS: A Tutorial and Survey,” IEEE Computer Graphics and Applications, Vol. 12, No. 5, pp.78-86, 1992.

5. S. S. Rao, Engineering Optimization Theory and Practice, Wiley-Interscience, 1996.

7. D. F. Rogers and N. G. Fog, “Constrained B-Spline curve and surface fitting,” Computer-Aided Design, Vol. 21, No. 10, pp.641-648, 1989.

8. W. Ma and J. P. Kruth, “Parameterization of Randomly Measured Points for Least Squares Fitting of B-Spline Curves and Surfaces,” Computer-Aided Design, Vol. 27, No. 9, pp.663-675, 1995.