正交分頻多工系統之資料訊號裁剪雜訊消除

Clipping Noise Cancellation for OFDM Systems with Clipped Data Signals

劉文仁(Wen-Ren Liu)

指導教授 ： 張大中

國立中央大學/資訊電機學院/通訊工程研究所碩士在職專班/碩士(2008年)

摘要

近年來正交分頻多工系統受到相當大的重視，在未來將是無線廣域網路的主要技術。但是變化過大的時域訊號會增加傳送功率的消耗，因此，我們必須利用限制傳送訊號的振幅來降低峰值平均功率比。但是限制傳送端的訊號振幅後，卻造成系統增加了剪裁雜訊 (Clipping Noise)。本論文探討在傳送端只對資料部份作訊號峰值的剪裁，保留了導引訊號以維持通道估計與同步處理的準確性，在接收端使用已發表過的Decision-aided reconstruction (DAR)及Clipping Noise Estimation and Cancellation (CNEC) 方法來消除剪裁雜訊對於系統的影響。模擬結果顯示，新的訊號剪裁方法搭配雜訊消除法可以更為提升系統性能。

關鍵字

裁剪訊號

並列摘要

In the past decade, the orthogonal frequency division multiplexing technique has received a lot of attention, which will be the main technology used in the wireless metropolitan area network (MAN) application. But a high signal amplitude variation can increase the design requirement of the power amplifier at the transmitter. To solve this problem, we can clip the transmitted signal to reduce the peak to average power ratio (PAPR). However, this will also induce the clipping noise.
In this paper, we study the method that only data signals are clipped and pilot signals are reserved at the transmitter in order to remain better channel estimation and synchronization performances. At the receiver, we apply the published methods, Decision-aided reconstruction (DAR) and Clipping Noise Estimation and Cancellation (CNEC), to reduce the effect of the clipping noise. Simulation results show that the new clipping method along with clipping noise cancellation algorithms can significantly improve the system performance.

並列關鍵字

clipping noise cancellation

參考文獻

OFDM systems using oversampled signal reconstruction,”IEEE

[2] D. Kim and G. L.Stuber, “Clipping noise mitigation for OFDM by

channel estimation in OFDM systems,”IEEE Commun.Letters,

[6] H. Ochiai and H. Imai, “Performance analysis of deliberately clipped

[7] X. Li and L. J. Cimini,, “Effects of clipping and filtering on the