轉向架活性銲接殘留應力分析之研究

A Study on the Residual Stress of Activated Welding Bogie Frame

陳韋豪(Chan Wei-Hao)

指導教授 ： 陳勇全

國立屏東科技大學/工學院/車輛工程系所/碩士(2020年)

https://doi.org/10.6346/NPUST202000479

摘要

無資料

關鍵字

轉向架 ； 銲接殘留應力 ； 雙橢球熱源模型 ； 活性銲接 ； 銲接順序 ； 銲接參數

並列摘要

無資料

並列關鍵字

Bogie Frame ； Residual stress ； Double Ellipsoid Heat Source Model ； Activated Welding ； Welding Sequence ； Welding Parameter

參考文獻

1. Vladislav, B., Mária, B., Michal, Š., Milan, V., and Milan, S., 2017,“Measurement and Numerical Analyses of Residual Stress Distribution Near Weld Joint” Procedia Engineering, Vol. 192 , pp. 22-27.

2. Chen, B. Q.,2016, “Effects of Plate Configurations on the Weld Induced Deformations and Strength of Fillet-Welded Plates” Marine Structures, Vol. 50, pp. 243-259.

3. Chen, Z., Chen, Z. C., and Shenoi, R., 2015, “Influence of Welding Sequence on Welding Deformation and Residual Stress of a Stiffened Plate Structure” Ocean Engineering, Vol. 106, pp. 271-280.

4. Deng, D, and Murakawa, H., 2005, “Numerical Simulation of Temperature Field and Residual Stress in Multi-Pass Welds in Stainless Steel Pipe and Comparison with Experimental Measurements”, Computational Materials ,Vol. 37,pp.269-277.

5. Eisazadeh, H., Achuthan, A., Goldak,J.A.,and Aidun,D.K.,2015,” Effect of Material Properties and Mechanical Tensioning Load on Residual Stress Formation in GTA 304-A36 dissimilar weld,” Journal of Materials Processing Technology,Vol. 222, pp.344-355.