具有不同連接基團之二酚所衍生的芳香族聚酯、聚醚碸及聚醚酮之合成與結構-性質研究

SYNTHESIS AND STRUCTURE-PROPERTY STUDY OF POLYARYLATES, POLY(ETHER SULFONE)S AND POLY(ETHER KETONE)S DERIVED FROM BISPHENOLS WITH DIFFERENT CONNECTOR GROUPS

江顯偉(Hsien-Wei Chiang)

指導教授 ： 蕭勝輝

大同大學/工程學院/化學工程學系所/碩士(2004年)

摘要

四種具有不同連結基團的二酚如 2,2-bis(4-hydroxyphenyl)-
propane (BPA)、 2,2-bis(4-hydroxyphenyl) hexafluoropropane (BPAF)、 1,1-bis(4-hydroxyphenyl)-1-phenylethane (BPAP) 及 1,1-bis(4-
hydroxyphenyl)-1-phenyl-2,2,2-trifluoroethane (BPAPF) 分別與各種芳香族二醯氯經由界面聚縮合或高溫溶液聚縮合反應製得數系列芳香族聚酯。這些聚酯的一些基本性質(如固有粘度、成膜性、結晶性、機械性質及熱性質等)及”結構-性質”的關係將加以探討。由不對稱結構二酚 BPAP 及 BPAPF 所衍生之芳香族聚酯比由相對應含對稱結構之二酚成份所衍生之芳香族聚酯顯示較低的結晶性及較高的溶解性及玻璃態轉移溫度 (Tg)。含氟的聚酯比相對應不含氟的聚酯顯示較高的熱裂解溫度。二系列聚醚碸和聚醚酮分別由 4,4’-difluorodiphenyl sulfone 與 4,4’-difluorobenzophenone和五種不同之二酚在CsF的存在下經由溶液聚縮合法製得。這五個二酚在芳香環間具有如下不同的連接基團：-C(CH3)2-、-C(CF3)2-、C(CH3)(C6H5)-、-C(CF3)(C6H5)-和–C(C6H5)2-等。這些聚醚的固有粘度在0.51-0.82 dL/g之間，其重量平均分子量和數平均分子量(由膠體滲透層析量測)分別在34,000-67,000和20,000-42,000之間。所製得之高分子均為非晶形的材質且易溶於數種有機溶劑並可製得具可撓曲性、強韌且具有良好機械性質之薄膜。這些由具有不同連接基團結構之二酚所合成之聚醚碸和聚醚酮的玻璃轉移溫度 (Tg)分別在189-221 oC及157-187 oC之間。無論在空氣或氮氣中，所有的聚醚在480 oC之前都不會產生明顯的熱裂解。這些聚醚的介電常數在3.33-3.67之間 (在 1 MHz測量的值)。其中含氟的聚醚較相對應不含氟的聚醚顯現較高的Tg、熱裂解溫度及較低的介電常數。為了性質比較，本研究亦合成了由hydroquinone和4,4’-bisphenol所衍生的聚醚並測定其性質。

關鍵字

聚醚酮 ； 聚醚碸 ； 芳香族聚酯

並列摘要

Several polyarylates were synthesized from the interfacial or high-temperature solution polycondensation reactions of four bisphenols including 2,2-bis(4-hydroxyphenyl)propane (BPA), 2,2-bis(4- hydroxyphenyl)hexafluoropropane (BPAF), 1,1-bis(4-hydroxyphenyl)-1- phenylethane (BPAP), and 1,1-bis(4-hydroxyphenyl)-1-phenyl-2,2,2- trifluoroethane (BPAPF) with various aromatic diacyl chlorides. The basic properties such as inherent viscosity, film-forming capability, crystallinity, and mechanical and thermal properties and the “structure-property” relationships of these polyarylates were investigated. The polyarylates derived from asymmetric BPAP and BPAPF had lower crystallinity and higher solubility and glass-transition temperature (Tg) than the corresponding counterparts based on symmetric BPA and BPAPF. The fluorinated polyarylates revealed higher Tg values and decomposition temperatures than the corresponding nonfluorinated polyarylates. Two series of poly(ether sulfone)s and poly(ether ketone)s were synthesized by solution polycondensation of 4,4’-difluorodiphenyl sulfone and 4,4’-difluorobenzophenone, respectively, with various bisphenols in the presence of cesium fluoride. Five bisphenols with different connecting linkages between the phenol units such as -C(CH3)2-, -C(CF3)2-, -C(CH3)(C6H5)-, -C(CF3)(C6H5)- and –C(C6H5)2- were used as the monomers. These polyethers had inherent viscosities of 0.51-0.82 dL/g that corresponded to weight-average and number-average molecular weights (by gel permeation chromatography) of 34,000-67,000 and 20,000-42,000, respectively. All polymers are amorphous and readily soluble in many organic solvents and can be solution cast into flexible and tough films with good mechanical properties. The glass-transition temperatures (Tg) of these poly(ether sulfone)s and poly(ether ketone)s have been measured in the range of 189-221 oC and 157-187 oC, respectively, depending on the structure of bisphenol connecting groups. All the polymers did not show significant decomposition before 480 oC in air or under nitrogen, and they had dielectric constants of 3.33-3.67 at 1 MHz. The fluorinated polymers showed higher Tg and decomposition temperatures and lower dielectric constants than the nonfluorinated counterparts. For a comparative study, polyethers based on hydroquinone and 4,4’-biphenol were also prepared and characterized.

並列關鍵字

POLY(ETHER KETONE)S ； POLY(ETHER SULFONE)S ； POLYARYLATES

參考文獻

2. Bier, G. Polymer 1974, 15, 527.

3. Vinogradova, S.V.; Vasnev, V. A.; Valetskii, P. M. “Polyarylates. Synthesis and properties,” Russ Chem Rev 1994, 63, 833.

4. Imai, Y.; Ishikawa, H.; Park, K. H.; Kakimoto, M. J Polym Sci Part A: Polym Chem 1997, 35, 2055.

5. Robeson, L. M.; Tibbitt, J. M. “History of Polyarylates,” In High Performance Polymers: Their Origin and Developments; Seymour, R. B.; Krishenbaum, G. S., Eds.; Elsvier: Amsterdam, 1986, pp 95-103.

6. Jeong, H.-J.; Kakimoto, M.; Imai, Y. J Polym Sci Part A: Polym Chem 1991, 29, 1293.