輪胎滾動阻力與模態之模擬分析

Simuation of Rolling Resistance and Modal Analysis for Tires

許榮均(Rong-Juin Shyu) ； 邱韋程(Wen-Cheng Chiu) ； 顏孝法(Yan-Shiau Fa)

《中華民國振動與噪音工程學會論文集》 2012 (2012/06) Pp. 151-158

https://doi.org/10.30028/CSSVANNUAL.201206.0151

摘要

近年來輪胎燃油經濟效率越來越受到重視，本文希望利用有限元素軟體ANSYS，以輪胎的材料特性為出發點，探討輪胎滾動阻力發生原因，並以此為基礎建立一套完整的輪胎變型與損耗能量的關係，且利用對205/55R16型輪胎進行的滾動阻力模擬分析，評估模擬方式的合理性，由此希望透過建立輪胎之有限元素分析流程來了解輪胎之力學特性。為了使輪胎模型符合真實輪胎狀況，所以本文亦將模擬光頭輪胎與複雜花紋輪胎之自然模態頻率，並將模擬結果與財團法人車輛研究測試中心所做的模態試驗做比對，並針對簾布層、鋼絲環帶層、尼龍束帶層等參數的簡化與假設來觀察其對模態頻率的影響，來探討出模擬值與實驗值的誤差原因及修正其參數，且改善模型的建構來降低誤差。以期可降低輪胎研發之時間與成本，並進一步用來取代傳統之試誤法。

關鍵字

輻射胎 ； 橡膠 ； 滾動阻力 ； 模態分析

並列摘要

The fuel economy of tires more and more attention in recent years. This paper uses finite element software for finite element simulation .Proceeding form the material properties of the tire, then probe the mechanism of rolling resistance, on the basis of which a complete set of tire deformation-energy analysis system is established. Furthermore, based on 205/55R16 tire rolling resistance simulation analysis to assess the rationality of the simulation method. Through finite element analysis process to comprehend mechanical properties of tires.In order to confirm the tire model conform the real tire, this paper also analysis natural frequencies and mode shapes of both inflated slick tires and pattern tires. The analysis results were used to compare with testing conducted by ARTC, also through simplification and assumptions the parameters about belts to observe influence. Use the parameters corrected for finite element model to make suggestion for fine tuning the finite element model. Expect to reduce the time and cost of the tire research and development, and replace the traditional trial and error method.

並列關鍵字

tires ； rubber ； rolling resistance ； modal analysis