透過您的圖書館登入
IP:3.147.43.65
  • 學位論文

高速微型化CMOS類比等化器

High Speed Miniaturized CMOS Analog Equalizers

指導教授 : 徐碩鴻
若您是本文的作者,可授權文章由華藝線上圖書館中協助推廣。

摘要


雖然inductive peaking技術可以有效地提升頻寬,但是使用傳統被動式電感,需要大量的面積。為了減少晶片面積與成本,在論文中,主要探討兩項有線通訊微型化CMOS類比等化器之設計、模擬與量測。 首先, 本論文實現一個90奈米製程的20 Gb/s微型化類比等化器。為了補償3公尺長的同軸電纜線在10GHz的10dB損耗,此等化器混合使用摺疊式主動電感與電容/電阻源極退化的技術。比起傳統主動電感與被動式螺旋電感,摺疊式主動電感消耗比較少的壓降與面積。在提供1.2伏的電壓下,此等化器的功耗45 mW,面積僅佔0.14 × 0.28 mm2。在18、19和20 Gb/s量測到最大峰對峰抖動值,分別是14, 13, 15 ps。 接著,本論文設計另一個使用立體微型電感之20 Gb/s微型化類比等化器。立體微型電感的等效電容比立體堆疊式電感小很多。根據模擬顯示,在同樣電感值與面積之下,立體微型電感的自諧振頻率比立體堆疊式電感高過10GHz以上。此外,在相同電感值的情況,立體微型電感所佔的面積,比起被動式螺旋電感,小了至少1/36倍。因此,利用立體微型電感可以降低晶片的尺寸與成本。此電路使用90奈米製程與1.2伏電壓,功耗14 mW,面積僅佔0.21 × 0.26 mm2。

並列摘要


The inductive peaking technique is effective to broaden the bandwidth, but it requires a large chip area. In this thesis, two high speed miniaturized CMOS equalizers up to 20 Gb/s are proposed for wireline communications. The equalizers are discussed regarding the design, simulation, and measurement results. Firstly, a 20 Gb/s miniaturized equalizer is realized in 90nm CMOS process. To compensate the coaxial cable loss of 10 dB (~ 3 meters) at 10 GHz, the equalizer incorporates folded active inductors with capacitive and resistive degeneration. Compared to the conventional active and spiral inductors, the folded active inductor consumes lower voltage and occupies less area. The circuit consumes 45mW from a 1.2 V supply, and only occupies 0.14 × 0.28 mm2. The measured maximum peak-to-peak jitter for 18, 19, and 20 Gb/s PRBSs are 14, 13, 15 ps, respectively. Next, another 20 Gb/s miniaturized analog equalizer using 3D solenoid inductors is presented. The equivalent capacitance of the 3D solenoid inductor is much smaller than that of the typical stacked inductor. According to the measurement results, the self-resonance frequency of the 3D solenoid inductor exceeds that of the stacked inductor by 10 GHz with the same area and inductance. In addition, the area of the 3D solenoid inductor is 1/36 times smaller than that of the spiral inductor with the same inductance. Hence, utilizing the small area of 3D solenoid inductor can reduce the size of the chip and lower the cost. The circuit, fabricated in 90nm CMOS process, consumes 14 mW from a 1.2 V supply, and only occupies 0.21 × 0.26 mm2.

參考文獻


[1] Y. Kudoh, M. Fukaishi, and M. Mizuno, "A 0.13-μm CMOS 5-Gb/s 10-m 28AWG cable transceiver with no-feedback-loop continuous-time post-equalizer," IEEE J. Solid-State Circuits, vol. 38, pp. 741-746, 2003.
[2] J. Lee, "A 20-Gb/s Adaptive Equalizer in 0.13-μm CMOS Technology," IEEE J. Solid-State Circuits, vol. 41, pp. 2058-2066, 2006.
[4] Z. Guangyu Evelina and M. M. Green, "A 10 Gb/s BiCMOS adaptive cable equalizer," IEEE J. Solid-State Circuits, vol. 40, pp. 2132-2140, 2005.
[5] Y. Tomita, M. Kibune, J. Ogawa, W. W. Walker, H. Tamura, and T. Kuroda, "A 10-Gb/s receiver with series equalizer and on-chip ISI monitor in 0.11-μm CMOS," IEEE J. Solid-State Circuits, vol. 40, pp. 986-993, 2005.
[6] J.-S. Choi, M.-S. Hwang, and D.-K. Jeong, "A 0.18-μm CMOS 3.5-gb/s continuous-time adaptive cable equalizer using enhanced low-frequency gain control method," IEEE J. Solid-State Circuits, vol. 39, pp. 419-425, 2004.

延伸閱讀