校正磨耗度之光柵測距輪

Abrasiveness Calibration of Optical Measuring Wheel

黃偉誠(Wei-Cheng Huang)

指導教授 ： 謝振榆

國立虎尾科技大學/電機資訊學院/光電與材料科技研究所/碩士(2014年)

摘要

本論文針對距離量測，提出一種簡單操作、實用性高的量測儀器。對於市面上的機械式測距輪主要是以機械式來計數距離，在輪子方面上僅有目測的方式，沒有針對輪子的磨耗度有效的監控，使用時間越久會導致輪子出現耗損的問題，逐漸的造成距離量測不準，為此本研究是利用盛群微控制器HT66F50，配合紅外線測距感測器、增量型編碼器，使其在微控制器上實現量測功能，並透過Measurement System Analysis進行驗證本量測系統是否符合量測系統規範。

關鍵字

測距輪 ； 磨耗度 ； 微控制器 ； 紅外線測距 ； 編碼器

並列摘要

The aim of this study is to propose a simple operation and highly practical measuring instrument. In response to conventional mechanical measuring wheels that mainly measure distance mechanically and inspect wheel wear visually, however, they are unable to monitor it effectively. As the wheel tends to generate wheel problems over time, it will gradually cause inaccurate distance measurement. Thus, a Holtek microcontroller HT66F50 was adopted to allow it to have a measuring function by coordinating with an infrared ranging module and an incremental encoder. Besides, Measurement System Analysis was further conducted to verify whether or not this measuring system is able to comply with the measurement system specifications.

並列關鍵字

Measuring wheel ； wheel wear ； microcontroller ； infrared ranging module for distance measurement ； encoder

參考文獻

[16]Chia-hao Chang,2010, “Speed Estimation Algorithms For Low-Resolution Encoders”, Lunghwa University Of Science And Technology.

[1]Guan-Jie Lyu, 2012, “ A study on the Design and Control of Line Tracking and Obstacle Avoidance for a Mobile Robot”, TaTung University

[2]Li T.-H.S, Shih-Jie Chang and Wei Tong, Fuzzy Target Tracking Control of Autonomous Mobile Robots by Using Infrared Sensors, IEEE Transactions on Fuzzy System, Vo1.12,mo.4,2004

[4]Deividson L. Okopnik ,Rosane Falate, Usage of the DFRobot RB-DFR-49 Infrared Sensor to detect maize seed passage on a conveyor belt, Computers and Electronics in Agriculture (2014) 106-111

(1998) 30–31.